CB 1-w
CB 1-w
Architectural & Engineering Specifications
1.0
GENERAL DESCRIPTION
1.1
2.0
The unit shall be a vandal-resistant communications device that is a multi-functional,
freestanding pedestal constructed of carbon steel with a top-mounted solar array, model CB
1-w from Code Blue Corporation, no substitutions. It shall include a high quality, hands-free
communications device illuminated by a high intensity faceplate light and a powerful
combination blue beacon/strobe light that serves to easily identify it from a distance.
CONSTRUCTION
2.1
The unit shall be a cylinder constructed of ASTM A500 seamless carbon steel structural
tube, schedule 20, 12.75” outside diameter x 0.25” thick wall, at a height of 117” and weigh
approximately 400 lbs.
2.2
The unit shall have an internal anchor base plate that is MIG welded 2” above the base and
fabricated with a minimum of 0.50” thick A-36 grade steel plate. It shall have a 5” diameter
center hole for electrical conduit access. The base plate shall have four oblong holes on an
8” circular bolt pattern for attachment.
2.3
An access door measuring 14” H x 9.64” W will be placed 13” from the bottom of the base
to provide access for mounting to the anchor bolts and connectivity to electrical facilities.
The opening shall have a cover plate, which mounts flush and is the same steel and radius as
the unit. The cover plate shall fit into the opening and have a weather-resistant gasket. The
cover plate shall be held in place by two ¼-20 x 1” countersunk proprietary fasteners.
2.4
Tamper resistant proprietary fasteners manufactured for Code Blue Corporation shall be
used. It shall not be possible to acquire the custom-designed bit from any other source.
2.5
A recessed opening shall be cut at a point beginning 38.5” above the bottom of the unit.
The opening shall be 14.5” tall at the forward edge and 12.25” tall at the rear edge, creating
a 35-degree angle from the horizontal and an arc of 160 degrees in the face.
2.5.1
3.0
The opening shall be enclosed by a 7 gauge steel plate with a single opening for a
communication device.
MOUNTING
3.1
The unit shall be mounted onto four anchor bolts that are set 0.50” above the concrete.
Standard 0.75” x 24” galvanized steel anchor bolts, nuts and washers shall be supplied.
3.2
The concrete foundation shall measure 24” x 24” minimum and the anchor bolts shall
protrude 6” from the foundation.
3.3
Unit shall include a weather-resistant, vented rubberized gasket mounted into the base to
prevent entry of sediment and pests.
Code Blue® ● 259 Hedcor Street ● Holland, MI 49423 USA ● 800.205.7186 ● www.codeblue.com
Specifications are subject to change without prior notice. Latest information available at www.codeblue.com.
Code Blue is a registered trademark of Code Blue Corporation.
CB 1-w
AE-103-M
Page 1 of 7
CB 1-w
Architectural & Engineering Specifications
4.0
ELECTRICAL
4.1
All electrical components shall have a modular plug for easy service and replacement, and
will be equipped with a fuse for protection from transient voltage conditions.
4.2
The unit shall be equipped with a 140-watt solar array with the following specifications:
Electrical Characteristics
STC Power Rating Pmp (W)
140
Open Circuit Voltage Voc (V)
22.0
Short Circuit Current Isc (A)
8.20
Voltage at Maximum Power Vmp (V)
17.3
Current at Maximum Power Imp (A)
7.50
Panel Efficiency
12.8%
Fill Factor
72.1%
Power Tolerance
-3.00% ~ 3.00%
Maximum System Voltage Vmax (V)
600v (US NEC) 1000v (IES 61215 rating)
Maximum Series Fuse Rating (A)
15A (S); 20A (J)
Code Blue® ● 259 Hedcor Street ● Holland, MI 49423 USA ● 800.205.7186 ● www.codeblue.com
Specifications are subject to change without prior notice. Latest information available at www.codeblue.com.
Code Blue is a registered trademark of Code Blue Corporation.
CB 1-w
AE-103-M
Page 2 of 7
CB 1-w
Architectural & Engineering Specifications
Temperature Coefficients
Temperature
Coefficiency of Isc
0.065 %/ºC
Temperature
Coefficiency of Voc
-0.80 %/ºC
Temperature
Coefficiency of Pmp
-0.50 %/ºC
Mechanical Characteristics
Cell Type
Polycrystalline Cell
Cell Size(mm)
156 × 156
Cells
4×9
Dimensions
1510.0 × 674.0 × 50.0mm (26.5 × 59.4 × 2.0 inch)
Weight
12.0Kg (26.5 lbs)
Standard J-Box, J-Version junction box with 6-terminal connection block; IP 65,
accepts PG 13.5, M20, ½-inch conduit, or cable fittings accepting 6-12mm
Junction Box (Safety
diameter cable. Terminals accept 2.5 to 10mm2 (8 to 14 AWG) wire.
Rating, Bypass Diodes)
IntegraBus™ technology includes Schottky bypass diodes integrated into the
printed circuit board bus
Positive Cable
(Length, Cable CrossSection)
800mm
Negative Cable
(Length, Cable CrossSection)
900mm
Plug Connector (Type,
Multicontact connectors
Safety)
Front Cover
(Thickness, Material)
High-transmission 3mm (1/8th inch) tempered glass
Backsheet Cover
(Color, Thickness,
Material)
Polyester
Code Blue® ● 259 Hedcor Street ● Holland, MI 49423 USA ● 800.205.7186 ● www.codeblue.com
Specifications are subject to change without prior notice. Latest information available at www.codeblue.com.
Code Blue is a registered trademark of Code Blue Corporation.
CB 1-w
AE-103-M
Page 3 of 7
CB 1-w
Architectural & Engineering Specifications
Encapsulation
Materials
EVA
Frame Material
Clear anodized aluminum alloy type 6063T6 Universal frame; Color: silver
Operation Conditions
Nominal Operating
Cell Temperature
(NOCT)
47.0°C
Operating
Temperature
-40.0°C to 85.0°C/-40°F to 185°F
Certification
o
o
o
o
Certificates
4.3
UL 1703
CEC California
IEC 61215 Ed.2
IEC 61730 Ed.2
The unit shall be equipped with a solar controller with the following specifications:
Electrical Characteristics
Rated Solar Input
10 A
Rated Load
10 A
25% Current Overload
5 min.
Regulation Voltage
Sealed Battery
14.1V
Flooded Battery
14.4V
Load Disconnect
11.7V
LVD Reconnect
12.8V
Temp. Comp. (mV/oC)
-27
Self-consumption
8 mA
Mechanical Characteristics
Wire Size
#10 AWG (5.2mm2)
Code Blue® ● 259 Hedcor Street ● Holland, MI 49423 USA ● 800.205.7186 ● www.codeblue.com
Specifications are subject to change without prior notice. Latest information available at www.codeblue.com.
Code Blue is a registered trademark of Code Blue Corporation.
CB 1-w
AE-103-M
Page 4 of 7
CB 1-w
Architectural & Engineering Specifications
Case
Anodized aluminum
Terminals
Marine rated
Electronics
Epoxy encapsulated
Weight
12.0Kg (26.5 lbs)
Operation Conditions
Operating Temperature
4.4
-40.0°C to 85.0°C/-40°F to 185°F
The unit shall be equipped with two batteries with the following specifications:
Electrical Characteristics
Nominal Voltage
Operating Temperature
12V
-40.0°C to 60.0°C/-40°F to 140°F
Capacity at 100oC
63 Ah
Capacity at 20oC
55 Ah
Mechanical Characteristics
Plate Alloy
Lead Calcium
Size
9.72” L x 5.47” W x 9.24” H
Weight
39 lbs
Posts
Forged Terminals & Bushings
Container/Cover
Polypropylene
Vent
Self-sealing
5.0
LIGHTS
5.1
LED Beacon/Strobe: Located in the dome top assembly with a rating of no less than 270
Lumens/92 candela, it shall have a factory-set flash rate of up to 375 flashes per minute and
be programmable. A deep blue UV-rated polycarbonate prismatic refractor shall surround
the LED Beacon/Strobe and be used to distribute light in a horizontal pattern for maximum
brightness and visibility.
5.1.1
The communication device shall be factory programmed to activate the LED
Beacon/Strobe for the duration of a call.
Code Blue® ● 259 Hedcor Street ● Holland, MI 49423 USA ● 800.205.7186 ● www.codeblue.com
Specifications are subject to change without prior notice. Latest information available at www.codeblue.com.
Code Blue is a registered trademark of Code Blue Corporation.
CB 1-w
AE-103-M
Page 5 of 7
CB 1-w
Architectural & Engineering Specifications
5.1.2
5.2
6.0
The LED Beacon/Strobe shall be 5.10” tall and 5.50” in diameter.
Faceplate light: LED will direct light onto the communications device and be vandal
resistant.
5.2.1
The opening shall measure 4.50” W x .50” H.
5.2.2
The light shall have a lifetime of 100,000 hours and a rating of 100 Lumens.
COMMUNICATIONS
6.1
The unit shall have a speakerphone communication device.
6.1.1
IP5000 - VoIP: Refer to the IP5000 Architect and Engineering Specification for
further information.
6.1.2
IA4100 - Analog: Refer to the IA4100 Architect and Engineering Specification for
further information.
6.2
The unit shall be capable of communicating via third party IP wireless and cellular devices,
which can be housed within the unit.
6.3
EIA/TIA, ANSI, CSA and BICSI cabling or similar standards shall be adhered to for proper
operation of devices connected to copper or fiber infrastructure.
7.0
FINISH
7.1
Four-coat paint process, with zinc-rich primer for corrosion resistance and baked-on
polyurethane enamel for maximum gloss and shine.
7.1.1
Optional clear coating process available to provide additional environmental
protection.
7.2
Substrate preparation shall be as required to comply with applicable ASTM impact and
adhesion standards: D2794 Direct and Reverse Impact, D523 Gloss @ 60 Degrees, D3359B
Cross hatch Adhesion, D1654 Corrosion Creep, D714 Scribe Blisters and D714 Field Blisters.
7.3
The finish shall be available in 12 standard colors: Safety Blue, Safety Red, Safety Yellow,
Midnight Blue, Gloss White, Gloss Black, Medium Bronze, Dark Bronze, British Racing Green,
Cardinal Red, Bright Silver and Tiger Orange. Custom colors shall be available.
7.4
Minimum coverage thickness of 2.0 mils.
8.0
COMPLIANCE
8.1
8.2
8.3
Americans with Disabilities Act (ADA) compliant
UL 60950-1 and UL 2017 listed
NFPA 72 Chapter 24 (2010) compliant
Code Blue® ● 259 Hedcor Street ● Holland, MI 49423 USA ● 800.205.7186 ● www.codeblue.com
Specifications are subject to change without prior notice. Latest information available at www.codeblue.com.
Code Blue is a registered trademark of Code Blue Corporation.
CB 1-w
AE-103-M
Page 6 of 7
CB 1-w
Architectural & Engineering Specifications
8.4
9.0
Meets NEMA 4X and IP56 requirements
GRAPHICS
9.1
Engineering grade reflective vinyl for high visibility and legibility.
9.2
Standard 3.25” tall and 30” long graphics text offerings: Emergency, Assistance, Security,
Courtesy, Police, Information or Help Point.
9.3
Standard graphics color offerings: Reflective White, Reflective Blue, Reflective Black,
Reflective Green, Reflective Red and Reflective Yellow.
9.4
Custom text, length and color options shall be available.
10.0 OPTIONS
10.1 Please refer to the associated Architect and Engineering Specification for the following
equipment:


WindAssist™ power generator
GSM Cellular
11.0 WARRANTY
11.1
The CB 1-w shall be warrantied against any defects in material and workmanship, under
normal use, for a period of 2 years from date of installation. If system is found by
manufacturer to be defective within the warranty period, manufacturer shall repair
and/or replace any defective parts, provided the equipment is returned to
manufacturer.
12.0 MANUFACTURER
12.1 The Manufacturer shall be Code Blue Corporation. 800-205-7186, 259 Hedcor Street,
Holland, Michigan 49423. www.codeblue.com. THERE ARE NO EQUIVALENTS.
Code Blue® ● 259 Hedcor Street ● Holland, MI 49423 USA ● 800.205.7186 ● www.codeblue.com
Specifications are subject to change without prior notice. Latest information available at www.codeblue.com.
Code Blue is a registered trademark of Code Blue Corporation.
CB 1-w
AE-103-M
Page 7 of 7
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement