MPP70 Hardware Kit Installation Instructions for CDM

MPP70 Hardware Kit Installation Instructions for CDM
MPP70 Hardware Kit
Installation Instructions
for CDM-570L Modem
Application Note
P/N: AN-MPP70HWKIT
Introduction
The MPP70 Hardware Kit supports the IP Module for the CDM-570L modem. The Kit can be installed at the
factory or added as a field-installed upgrade to CDM-570L modems currently deployed.
Kit Contents
Upgrade Kit Part Number KT/10922-70
HW/SEM440X1/4PH
4 each
4-40X1/4 SQ CONE PAN HD PHIL SS
PL-0001216
1 each
MODEM PACKET PROCESSOR
PL/9396-1
1 each
Cable – RJ11 to 9-Pin DSUB
Installation instructions
1 each
CAUTION: Obey precautions for handling electrostatic-sensitive devices.
CAUTION: Make sure that all of the pins are accurately aligned when you are installing
the MPP70 board.
Figure 1. MPP70 correctly installed in the CDM-570L modem
Copyright  2011 Comtech EF Data
-1-
(Part Number AN-MPP70HWKIT) Rev 0
Install the MPP70 Kit
1.
2.
3.
4.
5.
Stop the electrical power to the modem.
Disconnect the power cable.
Remove the screws from the top cover.
Remove the top cover.
Put the MPP70 board in position as shown in Figure 2. Make sure that the MPP70
connectors correctly engage with the rear panel holes.
6. You must do a visual inspection to make sure that all of the pins on the MPP70 are
accurately aligned with the female header. You must allow sufficient time to make
sure that all of the pins are accurately aligned.
WARNING: If any pin on the MPP70 is not aligned correctly, the modem will be
damaged when power is started.
7. Replace the top cover.
8. Replace the top screws.
9. Connect the power cable.
10. Start the electrical power to reinitialize the modem.
Firmware Flash Upgrade
1.
2.
3.
4.
5.
6.
7.
Go to www.comtechefdata.com
Click:
Support
Click:
Software Downloads
Click:
Download Flash and Software Update Files
Click:
Modems
Click:
CDM-570-IP
Select the applicable firmware zip file and download it.
8. The zip file contains installation instructions in a PDF file.
Install the
MPP70
in this area.
Figure 2. MPP70 properly installed in the CDM-570L modem
Copyright  2011 Comtech EF Data
-2-
(Part Number AN-MPP70HWKIT) Rev 0
Align the main board pins to
fit correctly into the female
header.
Figure 3. MPP70 Bottom side view
Install screws in four locations to
secure the board.
Make sure these connectors fit
correctly through the rear panel
slots of the modem.
Figure 4. MPP70 Bottom side view
Copyright  2011 Comtech EF Data
-3-
(Part Number AN-MPP70HWKIT) Rev 0
Figure 5. MPP70 board correctly installed in the CDM-570L modem
Copyright  2011 Comtech EF Data
-4-
(Part Number AN-MPP70HWKIT) Rev 0
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement