Husky Liners Installation Instructions 5729

Husky Liners Installation Instructions 5729
PART NO.
5729
95-02 GM S10 AND S15 TRUCK WITHOUT FENDER LIP MOLDING
95-97 GM S10 BLAZER AND S15 JIMMY WITHOUT FENDER LIP MOLDING
REAR MUD GUARD INSTALLATION INSTRUCTIONS
Please read instructions thoroughly before installation.
Tools Required
• 1/8” drill bit / Drill
• Short Phillips screwdriver
• Marking utensil (fine tip marker, grease pencil, etc.)
• Center punch / Hammer
•
•
•
Package Contents
Driver & passenger side rear mud guard
#10 screw (qty. 8)
Instruction sheet
NOTE: It may be necessary to remove the rear wheels depending on the tools being used for installation.
1.
2.
3.
4.
Clean and degrease the mud guard location area on the fender before installation.
Using mud guard as a template, mark, center punch, and drill 1/8” hole at location A (Figure 1).
Attach mud guard to fender with #10 screws at location A, check fit and level before tightening.
Mark, center punch, and drill 1/8” holes at locations B, C, and D and install #10 screws.
PAINTING INSTRUCTIONS
1. Clean mud guard with a soap and water solution to remove dirt and other contaminates.
2. Sand painting surface with 320 grit sand paper.
3. Apply a coating of flexible primer-adhesion promoter.
4. Apply a flexible paint as directed by the paint manufacturer.
5729 Rear Instructions.doc
Rev: 0
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement