Electric Heat Module Installation Instruction for

Electric Heat Module Installation Instruction for
NOTICE
The SCR Controller in this unit has been factory set to position #4 (2200 OHMS).
Due to shipping, handling and installation of the unit, the pre-set position may
have changed.
Before unit start-up, verify the switch is in the #4 position.
Any other switch position will cause improper heater function.
Switch Position = 4 (2200 ohms)
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement