B-8263 B-8263.18 AutomAtic LAvAtory-mounted

B-8263 B-8263.18 AutomAtic LAvAtory-mounted
Technical Data
Automatic
Lavatory-mounted
Foam soap dispenser
Specify Model Required:
 Model B-8263
 Model B-8263.18
B-8263
B-8263.18
Automatic Lavatory-Mounted Soap Dispenser
Starter Kit. Includes B-8263 Soap Dispenser, an 800ml lotion soap refill, 4 Alkaline D Cell Batteries
5-1/2''
1-7/8''
140mm
50mm
4''
105mm
15/16'' to 1/1-4''
24 to 32mm
Hole
7-3/4''
195mm
2''
50mm
Maximum
Mounting
Thickness
3-1/8''
80mm
1-5/8''
14-7/8''
40mm
375mm
5-5/8''
140mm
800ml
Lotion Soap Refill
(included in B-8263.18 only)
3-1/4''
80mm
Battery Pack
(4 Alkaline D Cell Batteries included in B-8263.18 only)
Dia.
MATERIALS:
Spout Cover Assembly — Bright Polished chrome plated plastic with LED light indicators. Red blinking LED indicates soap
level is low, Yellow blinking LED indicates battery life is low. Equipped with integral plastic shank.
Motor Assembly — Water resistant, plastic construction, fits onto bottom of shank and top of soap refill.
Batter y Pack — Water resistant, plastic material, holds 4 Alkaline "D" Cell Batteries. Batteries are included in Model
B-8263.18 Starter Kit only. Average battery life is 90,000 cycles or 2 years.
Soap Refill — OneShot® Soap Refill. Translucent, shatter-resistant polyethylene bottle. Includes new supply tube and pump
mechanism in each refill. Soap refill available in 27-fl oz (800ml) and 54-fl oz (1600ml) capacities. One 27-fl oz (800ml) bottle of
Lotion Hand Soap with Moisturizers is included in Model B-8263.18 only. OneShot® is a registered trademark of Rubbermaid
Commercial Products.
Optional Spacer — Plastic spacer is included for mounting dispenser when sink rim is 3/4" (19mm)high or greater.
OPERATION:
Place hand under soap spout for approximately 2 seconds. Spout will dispense controlled amount (0.8ml) of Lotion Hand Soap
with Moisturizers or Free n'Clean Soap. 27-fl oz (800ml) soap refill provides 1000 hand washes, the 54 fl oz (1600ml) soap refill
provides 2000 hand washes. Motor assembly is preset for 27-fl oz (800ml) soap refill (if 54-fl oz (1600ml) is used, a switch under
the rubber plug next to red reset button must be moved to 2K). Once a new soap refill is connected, pressing the red reset
button automatically resets the low soap indicator LED and primes the new soap refill.
continued . . .
The illustrations and descriptions herein are applicable to production as of the date of this Technical Data Sheet.
Issued 8/27/10
Printed in U.S.A.
The manufacturer reserves the right to, and does from time to time, make changes and improvements in designs and dimensions. © 2010 by Bobrick Washroom Equipment, Inc.
INSTALLATION:
Unit is designed for installation in 15/16" to 1-1/4" (24 to 32mm) diameter hole in porcelain-enameled steel, cast iron
or vitreous-china lavatories, as well as in countertops adjacent to lavatories. Unit may be mounted in unused faucet hole
or through special hole requisitioned when lavatory is ordered from manufacturer (specify punching location). Shank
accomodates maximum 2" (50mm) mounting thickness. Clearance required for soap refill bottle and motor housing is 5"
(125mm) for the 27-fl oz (800ml) soap refill and 5-½" (140mm)diameter for 54-fl oz (1600ml) soap refill and 11-5/8" (295mm)
minimum depth for height of 27-fl oz of soap refill bottle and motor housing and 13-5/8" (345mm) minimum depth for height of
5-fl oz. (1600ml) soap refill bottle and motor housing. Place 4 "D" Cell Batteries (included in Model B-8263.18 only) into battery
pack. An optional single 6V AC adapter to replace the battery pack is available, order Part No. 826-20.
27-fl oz.
800ml
54-fl oz.
1600ml
Diameter of Bottle
and Motor
5''
125mm
5-1/2''
140mm
Clearance Below
Counter
11-5/8''
295mm
13-5/8''
345mm
SPECIFICATION:
Automatic Lavatory-Mounted Foam Soap Dispenser shall dispense controlled amount (0.8ml) of Lotion Hand Soap with
Moisturizers or Free n'Clean Soap or Lotion Hand Soap. Spout cover assembly to be Bright Polished chrome plated plastic.
Meets Barrier-Free accessibility standards. Unit shall have blinking LED indicators to show low soap level and low battery
life. Shank shall accommodate mounting thicknesses up to 2" (50mm). Translucent, shatter-resistant polyethylene soap refill
(800ml soap refill included in model B-8263.18 only) shall have capacities of 27-fl oz (800ml) or 54-fl oz (1600ml).
Automatic Lavator y-Mounted Foam Soap Dispenser shall be Model B-8263 of Bobrick Washroom Equipment,
Inc., Clifton Park, New York; Jackson, Tennessee; Los Angeles, California; Bobrick Washroom Equipment
Company, Scarborough, Ontario; Bobrick Washroom Equipment Pty. Ltd., Australia; and Bobrick Washroom
Equipment Limited, United Kingdom.
The illustrations and descriptions herein are applicable to production as of the date of this Technical Data Sheet.
B-8263-200 i8/27/10
Printed in U.S.A.
The manufacturer reserves the right to, and does from time to time, make changes and improvements in designs and dimensions.
© 2010 by Bobrick Washroom Equipment, Inc.
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement