DC50 DM50.SalesLiterature
Climatic 50
DS50 DC50 User Interface
Providing indoor climate comfort
FEATURES AND BENEFITS
CONTROL OPTIONS
Advance control pack
Where a higher level of controllability is required to make the
Baltic even more flexible, LENNOX have compiled a pack that
includes two advanced control features.
-"Enthalpy control on economiser".
Software and its sensors will ensure that the economiser does
not use 100% fresh air if the outside air has a higher enthalpy
than the return air. This feature is relevant in regions where the
relative humidity is high or when the desired room air condition
is very dry.
- "Humidity control" software and its sensors, are able to analyze
dry and wet bulb temperatures, and therefore can control a dehumidification algorithm. This will dehumidify the air in cooling
mode as it passes through the coil, then reheating it with either
electric heater or hot water coil. If there is a need to humidify
the air, a proportional contact is now available to control a humidfierthat will be provided by the customer.
options and accessories
DS 50 : Service Display
This new service display controller directly plugs on the external
wall of the unit.
This allows service personal to set up to 90 settings, read up
to 125 variables, up to 45 faults and read the history of the last
16 faults.
This controller has been designed to be very user friendly, with
6 different keys, a 4 lignes display and this controller includes
scrolling menus and true language (no codes). It will be in English
or an other alternate language.
TCB (Thermostat Control Board)
This board has been developped for any customer who wants
to take over the control of the unit. With 6 logical inputs (Compressor stage 1 and stage 2, heating step 1 and 2, 4 way valves
and fan), this board will replace the control algorythm. However
CLIMATIC™ 50 controller will stay in charge of all safety algorythm, defrost operation or free cooling operation. All Input are
volt free contact.
This is the perfect board, to have BALTIC rooftop managed by a
zoning system, a universal thermostat or even a BMS system.
Communication interface / Modbus interface
Electronic board needed for Climalink or Climalook use. One
board required per rooftop.
This board is a well a modbus interface, which is needed for
anyone who would like a BMS system to talk to the Baltic with
"Modbus protocol". No other hardware than this board is required
to have modbus dialog. One board required per rooftop.
DC 50 : Comfort Display
This is a remote controller for non-technical customer. It has been
wanted to aesthetically fit inside a room and be very easy to use.
It can be installed at maximum 500 meters from the unit.
This graphical display gives information such as running mode
of the unit, status of the fan, set point, % of fresh air, outside
air temperature.
Customer can change the scheduling of the different time zone,
can modify temperature set point and % of fresh air for each
zone. Customer can also overide the scheduling in either changing the set point for 3 hours or in forcing the rooftop to unoccupied mode for 1 to 7 days. ON/OFF key is also available.
DC50 Comfort display, shows faults number when rooftop is in
the failure mode. Customer can reset fault thanks to a combination of keys.
Time and day of the rooftop can be seen and modified easily
through the DC50.
LonTalk® interface
This board is a LonTalk® interface, which is needed for anyone
who would like a BMS system to talk to the Baltic with «Lon protocol» with FTT10. No other hardware than this board is required
to have LonTalk® dialog. One board required per rooftop.
Bacnet® interface
This board is a Bacnet® interface, which is needed for anyone
who would like a BMS system to talk to the FLEXY II with “Bacnet
protocol» RS485.
FEATURES AND BENEFITS
- OPTIONS AND ACCESSORIES
ADALINK
Adalink is the solution for HVAC installation monitoring. It can
control up to 32 units on the same site. Real gateway to the unit,
Adalink can be used locally, via LAN network or directly plugged.
It can be used remotely via modem.
1
2
32 max
3
Direct connection on PC,
using Internet Explorer®
Adalink™
Wireless
Following customer request and last technologies development, LENNOX is able to provide you a wireless customer
display DWC 50 for your Roof Top. A repeater connected to
the main board of the CLIMATIC 50 with a RS 485 connection, communicate through a ZIGBEE protocol to the wireless
customer display located in the ambient.
or
Connection on local
area network,
using Internet Explorer®
Phone
Distant customer,
using Internet Explorer®
Adalink can show the whole site map showing status of the different units, zoom on each unit and allow the user to graphically
change set point, access alarm list, look at trend curves. It is the
ideal tools for maintenance specialist with an expert mode giving
access to all the parameters and set point of the unit.
The DWC 50 display is equipped with a battery (5 yrs
consumption) and a embedded sensor. This wireless display
wall-mount, desk-top or hand-held. In addition if you want a
more accurate ambient temperature measure in big volume,
additional wireless sensor are available and in this case the
display will communicate the average temperature of the
sensors.
Finally, yearly scheduling is possible with a very smart and userfriendly drag and drop system.
5
4
3
2
DC50
6
2
J4
A
3
3
B
DS50
2
-DT50
6
J5
Cable c.sect.(mm2)
3twisted pair
AWG24
500m maxi
0
C
BM 50
J0
5
4
3
2
DC50
6
2
J4
A
3
3
B
DS50
2
-DT50
6
J5
Cable c.sect.(mm2)
3twisted pair
AWG24
500m maxi
RT
0
C
BM 50
J0
5
4
3
2
DC50
6
2
J4
A
3
3
B
DS50
2
-DT50
6
J5
Cable c.sect.(mm2)
3twisted pair
AWG24
500m maxi
RT2
0
C
BM 50
J0
5
4
3
2
DC50
6
2
J4
A
3
3
B
DS50
2
-DT50
6
J5
Cable c.sect.(mm2)
3twisted pair
AWG24
500m maxi
RT3
0
C
BM 50
J0
RT2
COMMUNICATION Link
DS 50 : SERVICE DISPLAY / DC 50 : COMFORT DISPLAY
6
5
4
3
2
DC50
LAN
1
1
2
J14
A
3
1
3
B
DS50
2
-DT50
6
J15
Cable c.sect.(mm2)
3twisted pair
AWG24
500m maxi
0
C
J11
BM 50
SERIAL CARD
J10
5
4
3
2
DC50
6
1
1
2
J14
A
3
1
3
B
DS50
2
J15
-DT50
6
0
C
J11
BM 50
SERIAL CARD
Cable c.sect.(mm2)
3twisted pair
AWG24
500m maxi
RT1
J10
5
4
3
2
DC50
6
1
1
2
J14
A
3
1
3
B
DS50
2
-DT50
6
J15
Cable c.sect.(mm2)
3twisted pair
AWG24
500m maxi
0
C
J11
BM 50
SERIAL CARD
Cable c.sect.(mm2)
2twisted pair
AWG24
500m maxi
RT2
J10
5
4
3
2
DC50
6
1
1
2
J14
A
3
1
3
B
DS50
2
J15
-DT50
6
0
C
J11
BM 50
SERIAL CARD
Cable c.sect.(mm2)
3twisted pair
AWG24
500m maxi
RT3
J10
LAN
RT12
COMMUNICATION Link
MASTER / SLAVE
www.lennoxeurope.com
BELGIUM, LUXEMBOURG
www.lennoxbelgium.com
PORTUGAL
www.lennoxportugal.com
Due to Lennox’s ongoing commitment to quality,
the Specifications, Ratings and Dimensions are
subject to change without notice and without
incurring liability.
CZECH REPUBLIC
www.lennox.cz
RUSSIA
www.lennoxrussia.com
Improper
installation,
adjustment,
alteration,
service or maintenance can cause property
damage or personal injury.
Installation and service must be performed by a
FRANCE
www.lennoxfrance.com
SLOVAKIA
www.lennoxdistribution.com
GERMANY
www.lennoxdeutschland.com
SPAIN
www.lennoxspain.com
GREAT BRITAIN
www.lennoxuk.com
UKRAINE
www.lennoxrussia.com
NETHERLANDS
www.lennoxnederland.com
OTHER COUNTRIES
www.lennoxdistribution.com
POLAND
www.lennoxpolska.com
CL50-CHILLERS-IOM-0906-E
qualified installer and servicing agency.
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement