Replaceable Filter Cores - ADKS (PA

Replaceable Filter Cores - ADKS (PA
Instruction Sheet
PA-00139
June 2013
Replaceable Filter-Drier Blocks & Filters
with ADKS Take-Apart Shells
Replaceable Filter-Drier Blocks & Filters with ADKS Take-Apart Shells
SAFETY INSTRUCTIONS
1.
Read installation instructions thoroughly. Failure to follow
instructions may result in drier failure or system damage.
2. Do not remove blocks from bag until just prior to installation.
Early removal could result in contamination of the desiccant
from surrounding atmosphere.
3.CAUTION: In a severely contaminated system, avoid
breathing acid vapors and avoid contact with the skin or
clothing from contaminated refrigerant. Dispose the
contaminated refrigerant in a caustic solution. Failure to do
so may cause personal injury.
4. Thoroughly leak test system after installation. Failure to do
so could result in loss of refrigerant.
5.
These products are intended for use on the following
refrigerants up to a maximum working pressure marked on
the product: CFC's, HFC's, mineral oil, POE and
alkybenzene.
Do not use Emerson filter-driers on any other unlisted
gas or fluid media without prior approval of the Emerson
Climate Technologies Flow Controls Applications
Engineering Department. Use on fluids not listed could
result in chemical deterioration of the filter-drier.
6. The F series filters should not be used for liquid line or hot
gas applications.
DO NOT OPEN BAG UNTIL READY TO INSTALL
BLOCK OR SUCTION FILTER CORE
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
12.
13.
14.
Pump down the system and the ADKS shell completely.
Remove flange bolts, flange cover, and flange gasket.
Withdraw internal assembly by pulling firmly on inlet block
retainer. Resistance will occur due to snug fit of outlet block
retainer.
Unscrew inlet block retainer counter-clockwise while holding
outlet retainer firm.
Remove used filter-drier or suction filter core. For multiple
block or core units, also remove block gasket or suction filter
coupling.
Clean all internal parts thoroughly.
Remove block or filter core from packaging and reassemble
as rapidly as possible to minimize moisture contamination.
Slip new block or core on strainer assembly. With multiple
block or core units, place block gasket between each block,
or core coupling between each core.
Screw inlet block retainer firmly into strainer assembly and
carefully insert assembled unit into shell.
Install new flange gasket into flange cover and secure to
shell with two flange bolts in diagonally opposite holes.
Install the remaining bolts snugly.
Torque all flange bolts evenly in a criss-cross pattern to
torque of 36 ft/lbs maximum.
Test for leakage.
Replace the suction line filter-drier blocks with suction line
filters to minimize suction line pressure drop, but still providing compressor protection.
WARNING: Do not use suction filters on liquid line applications.
ADKS Series
EmersonClimate.com/FlowControls
Technical Support: 1-866-625-8416
PA-00139 (06/13) Emerson is a trademark of Emerson Electric Co. ©2013 Emerson Climate Technologies, Inc. All rights reserved.
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement