Procon Pumps

Procon Pumps
Procon Pumps
For ALL MOTORS - Installing The Plumbing
When you finish mounting your pump on a motor, you must install the
plumbing for the pump. Follow these steps after you have mounted your
pump.
1. Install the inlet and outlet fittings.
Support the pump by using a backup wrench
on the square port bosses. Do not put any
strain on the V-band clamp.
Use brass fittings or plastic fittings on a brass
pump. Use stainless steel or plastic fittings on
a stainless steel pump. Using dissimilar metals
can cause corrosion, which may get into the
pump and cause damage.
Use a backup wrench on the
Use Teflon thread tape to install the fittings.
square port boss to support the Do not let any thread tape get into the pump
pump.
and do not over-tighten the fittings.
2. Check the inlet line.
Make sure that the inlet line is big enough to
allow adequate flow to the inlet port of the
pump (3/8 inch internal diameter for Series 1, 2,
3; 1/2 inch internal diameter for Series 4&5; 1
inch internal diameter for Series 6; all elevated
temperature applications above 150º F must
have oversized inlet piping).
Make sure the inlet line is clean and properly
flushed out. Protect the pump with a 100 mesh
or finer strainer or filter.
3. Connect the inlet line to the fitting on the
pump.
4. Connect the outlet line to the fitting on the
pump.
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement