Pantheon PL1 User Manual

Pantheon PL1 User Manual
Plate Lowerator
PL1 Operating Manual
Introduction
Thank you for purchasing a Pantheon Catering Equipment product. In this
booklet you will find instructions for safe operation so please read carefully
and retain for future reference.
Warnings and Precautions
The following warnings and precautions are important and must be observed:
• Ensure voltage and frequency power requirements for the plate
lowerator match that of the supply.
• The machine must be earthed when used. There is a danger of electric
shock if it is not earthed.
• In case of emergency, please turn off the power switch and unplug the
machine.
• If the electric wire becomes damaged, a qualified engineer or the
manufacturer must replace it.
• When the plate warmer is switched on and in operation, be careful of
hot components.
Pantheon Catering Equipment is not responsible for any accidents or faults
caused by amendments made to the machine or improper use by the user.
Technical Data
Specifications:
Model:
Voltage (V)
Power (W)
Capacity (plates)
Plate Diameter (mm)
Weight (Kg)
Dimensions (mm)
PL1
220-240V 50Hz
400
75
230-310
19
ф405 x 725h
Installation
The installation of the unit must be performed by a qualified technician only.
Place the device on top of a solid, even, safe and stable surface that tolerates
the weight of the plate warmer.
Position the device appropriately so that the plug is always accessible.
Ensure the electrical components of the warmer are well away from water.
Each plate warmer is equipped with 24 springs. This is the required amount to
balance 75 plates. All the springs are furnished in this equipment when the unit
leaves the factory. You may reduce the quantity of springs to meet your
requirements, however, please ensure there are still enough present to
support the amount of plates you wish to store. If you wish to release any
springs, please release them from the bottom end.
Operating Instructions
1. Connect the unit to a suitable power supply and turn the main switch
on.
2. The plate warmer should begin to heat the crockery immediately, once
turned on.
3. The plate warmer has a spring system which is variable to accommodate
different weights of plates. Please refer to the ‘installation’ section of
this instruction manual to find out more.
4. After you have finished with the plate warmer, turn off the main switch
and turn it off at the mains.
Circuit Diagram
Parts Diagram
Parts List
Serial No.
1
Name
Screw
2
Bottom plate
3
4
5
6
7
8
9
Power cord
Fixed head for cable
Shell
Heating element
Shelf
Spring
Switch
Plate for holding
plates
10
Material
Steel M4×8
Aluminium plating sheet
δ=0.6
3×1mm2
ABS
SUS304
230V 400W
SUS304
GB4358 G2
250V/25A
Quantity
10
SUS430 δ=1.2
1
1
1
1
1
1
24
1
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement