#3610 User's Guide
Illuminated Gel Board #3610
USER’S GUIDE
For Technical Support:
Call our Technical Service Department
Monday through Friday, 9 a.m. to 5 p.m. (EST)
1-800-TEC-TOYS or 1-800-832-8697
[email protected]
50 Broadway
Hawthorne, NY 10532
Tel. 914.747.3070 / Fax 914.747.3480
Toll Free 800.832.8697
www.enablingdevices.com
A great sensory experience!
Our Gel Board provides both visual and tactile experiences. Four
colorful soft and squishy pads light up when you touch them. Each pad
contains multicolored stars that move when you press the pad. Pads
light up with the slightest touch. A bead chain and mirror invite
additional exploration. Use on a desktop or wall mounted. Wall
mounting hardware included. Size: 16½"L x 13½"W x 2"H. Requires 2
AA Batteries. Weight: 3½ lbs.
1. Illuminated Gel Board requires 2 AA batteries (not included). Use
Alkaline batteries only (e.g. Duracell or Energizer brand). Do not
use rechargeable batteries or any other type of batteries because they
supply lower voltage and the unit will not perform properly. The
battery compartment is located under the mirror. To access the
compartment lift off the Velcro attached mirror and then remove the
Phillips Head screw from the battery compartment cover. Install the
AA batteries into the holder. When installing new batteries, always
be careful to observe battery polarity. Replace battery cover and
screw. Never mix old and new batteries together or different brands
or types together.
Troubleshooting:
Problem: UV Light Panel’s lights do not work.
Action #1: Make sure the ON/OFF toggle switch is turned ON.
Action #2: Check the Batteries for strength and for proper battery
polarity. Replace if weak or dead.
Care of the Unit:
The Illuminated Gel Board can be wiped clean with any household
multi-purpose, non-abrasive cleaner and disinfectant. We recommend
Simple Green, which is a non toxic biodegradable all-purpose cleaner.
2. Turn the ON/OFF toggle switch to ON. Our Gel Board provides
both visual and tactile experiences. Four colorful soft and squishy
pads light up when you touch them. Each pad contains multicolored
stars that move when you press the pad. Pads light up with the
slightest touch. Once you release pressure on the gel pad the light
will go out. A bead chain and mirror invite additional exploration.
Use on a desktop or wall mounted. Wall mounting hardware
included.
Do not use abrasive cleaners, as they will scratch the surface of the unit.
Do not submerge the unit, as it will damage the electrical components.
Rev 9/1/15
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement