EJ15-2 Series Spec Sheet

EJ15-2 Series Spec Sheet
TECHNICAL DATA
Dwg:
DS-S08-018
Rev:
A
Date:
SCAVENGER E SERIES
1/19/06
Scavenger
Section
Tab
EJ 15-2
Ejector
Page
MOTOR SPECIFICATIONS
NEMA design B, squirrel cage induction, oil filled, non toxic oil
Enclosed submersible
Class B, rated at 120° C
Single Phase: Internal thermal protection with automatic reset. Installer must provide
circuit breaker for short circuit protection per N.E.C standards.
Three Phase: Installer must provide external motor overload protection device such as a
contactor w/ thermal relay, and circuit breaker for short circuit protection per
N.E.C. standards.
1.15
± 10% from name plate rating
Motor Design
Motor Type
Insulation Class
Motor Protection
Service Factor
Voltage Tolerance
MOTOR DATA, 60Hz
Model
Phase
EJ 15W-2
1*
Output
Power
bhp
1.5
EJ 15D-2
3**
3**
3
1.5
1.5
1.5
230
Full
Load
Amps
15.0
Locked
Rotor
Amps
59
NEMA
Code
Letter
L
Pole/
Speed
(rpm)
4/1750
208-230
460
575
7.7-7.0
3.5
2.8
45-40
20
16
M
M
M
4/1750
4/1750
4/1750
Volts
* Start switch and capacitor integrated into top of pump.
** These three phase motors are tri-voltage, 208/230/460.
MATERIALS of CONSTRUCTION
Upper Motor Lid
Motor Housing
Oil Chamber
Volute
Bottom Plate
Impeller
Lifting Bail
Oil (motor & oil chamber)
External Hardware
O-Rings
Motor Shaft
Upper Bearing
Lower Bearing(s)
Upper Shaft Seal (secondary)
Lower Shaft Seal (primary)
Cast Iron ASTM A48 Class 30
Cast Iron ASTM A48 Class 30
Cast Iron ASTM A48 Class 30
Cast Iron ASTM A48 Class 30
Cast Iron ASTM A48 Class 30
Cast Iron ASTM A48 Class 30
AISI 304 Stainless Steel
Non-toxic white mineral oil (Marcol 52)
AISI 304 Stainless Steel
Buna-N
AISI 420 Stainless Steel
Single row ball bearing
Single row ball bearing
Rotating carbon face w/ stationary ceramic face.
Rotating carbon face w/ stationary ceramic face. Includes V-ring lip seal for
lower seal protection. Option: Silicon Carbide mechanical seal
DIMENSIONS, WEIGHT, AND MISC.
Pump weight, lb. (kg)
Maximum submergence, ft. (m)
Discharge size, standard
Discharge type
Maximum temp. of pumped fluid
Agency Approvals
90 (41) [EJ 15W-2], 84 (38) [EJ 15D-2]
65 (20)
2 inch horizontal
Flange with standard ANSI class 125 bolt pattern.
40°C continuous, 50°C intermittent
UL 778 and CSA C22.2-108
CABLE SPECIFICATIONS
POWER CABLE
14/3 SJEOOW (EJ 15W-2)
16/4 SEOOW (EJ 15D-2)
Specifications subject to change without notice
VOLTAGE
230
208-230/460/575
DIAMETER
0.36in (9.2mm)
0.43in (10.9mm)
LENGTH
OUTER JACKET
20 ft (6m)
Thermoplastic elastomer
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement