JSJS LW105 5 Button Remote

JSJS LW105 5 Button Remote
LightwaveRF
connect
5 Button Remote
Operation Manual
Model No: JSJS LW105
It is important to install this product in accordance
with the fitting instructions below. Failure to do so
may render your guarantee void.
IMPORTANT: PLEASE RETAIN THESE INSTRUCTIONS
FOR FUTURE REFERENCE AND FOR GUIDANCE ON
THE ASSOCIATION OF REMOTE HANDSETS. FOR
HELP AND SETUP GUIDANCE PLEASE VISIT
www.lightwaverf.com
OVERVIEW:
The LightwaveRF Connect 5 Button Remote is
designed to control LightwaveRF Connect CFR
remote control bulbs or any other remotely
controllable products in the range.
SETUP:
The functions illustrated here relate to the operation
of a dimmable CFR. For information regarding how to
pair the remote to the relevant receiver/s please refer
to the setup instructions for that individual device.
Before operation, ensure that the plastic film isolating
the battery is removed.
NOTE: If the RF distance between the transmitter and
receiver is too great to achieve reliable operation, the
LightwaveRF Connect SIGNAL BOOSTER may be
used in conjunction with this product to increase the
signal strength over greater distances.
OPERATION:
To operate a dimmable CFR
NOTE: If operating a CFR, make sure that the wall
switch is initially turned ON .
Switch ‘ON/OFF’
There are two sets of ‘ON/OFF’ buttons. You can
choose to pair either set of buttons (see instructions
of the receiver device to pair it).
• Press the ‘ON’ button once to
switch paired devices on.
• Press the ‘OFF’ button once to
switch paired devices off.
• Press the ‘ALL OFF’ button once
to switch off all paired bulbs.
Dimming down
1. Make sure the light is switched
on.
2. Hold down the ‘OFF’ button on
the remote.
3. After 1 sec. the light will start to
dim down.
NOTE: If the ‘OFF’ button is not released, the light will
continue to dim until no light is emitted and stop,
although the switch remains on, illustrated by the
illuminated blue LED.
Raising Dim Level
1. Make sure the light is switched on.
2. Hold down the ‘ON’ button on the remote.
3. After 1 second the light will start to become
brighter.
4. At the desired brightness release the ‘ON’ button.
NOTE: If the ‘ON’ button is not released, the light level
will increase until it stops at the maximum possible
level of brightness
Battery Replacement
Slide down the back cover and use a small
screwdriver to remove the battery.
• Connect correctly and secure
• Do not recharge
• Keep away from children
• Do not swallow (If swallowed, seek medical advice
immediately)
• Please dispose of used batteries responsibly
SPECIFICATION:
RF frequency: 433.92 MHz
3V CR2032 Lithium battery included
Birmingham Science Park Aston
Faraday Wharf
Holt Street
Birmingham
B7 4BB
Tel: 01902 500 562
Email: [email protected]
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement