QFP48 TET
_
V1.4
Adapters
QFP48
Target CPU package: QFP48
Body size: 7mm x 7mm
Pitch: 0.5 mm
POD target layout: T_QFP48A
Can be used with:
• 78K0R/Fx3 ActiveGT POD
• R8C/3x ActivePRO POD
• 68HC08GR POD
• 68HC08GR Active POD
• 78K0/Kx2 ActivePRO POD
• 78K0/Fx2 Active PRO POD
Described adapter parts can be used only with listed PODs. Disregarding this
warning may result in a hardware failure of the target and the emulation system.
Available Adapter Parts (by ordering code):
•
IA48TQ-SOLDER
Solder part, which is soldered down to the target.
Recommended PCB footprint size (by TET):
(Unit : mm)
C Size
10
 iSYSTEM, April 2013
D Size
10
E Size
1.75
1/2
•
IA48TQA-WIRE
IA48TQA-WIRE represents flexible connection between the POD and the target.
Assembly
Pay extra attention to pin 1 when assembling the adapter and connecting the POD to
the target since a mistake can damage the hardware.
1. First, connect IA48TQA-WIRE to the POD.
2. Next, solder down the IA48TQ-SOLDER to the target PCB
3. Finally, connect the POD to the soldered IA48TQ-SOLDER.
Disclaimer: iSYSTEM assumes no responsibility for any errors which may appear in
this document, reserves the right to change devices or specifications detailed herein
at any time without notice, and does not make any commitment to update the
information herein.
 iSYSTEM. All rights reserved.
 iSYSTEM, April 2013
2/2
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement