JennAir JIC4430XB Induction Cooktop Guide

30" (76.2 CM) AND 36" (91.4 CM) ELECTRIC INDUCTION COOKTOP
PRODUCT MODEL NUMBERS
CABINET DIMENSIONS
JIC4430X
IMPORTANT: If installing a range hood or microwave hood combination above the
range, follow the range hood or microwave hood combination installation instructions for
dimensional clearances above the cooktop surface.
JIC4536X
ELECTRICAL REQUIREMENTS:
Before You Make the Electrical Connection:
To properly install your cooktop, you must determine the type of
electrical connection you will be using and follow the instructions
provided for it here.
● A 4-wire or 3-wire, single phase, 240 volt, 60 Hz., AC only electrical
supply is required on a separate, 50-amp circuit (36" [91.4 cm]
models) or 40-amp circuit (30" [76.2 cm] models), fused on both
sides of the line.
● The cooktop should be connected directly to the junction box through
flexible, armored or nonmetallic sheathed, copper cable. The flexible,
armored cable extending from the fuse box or circuit breaker box
should be connected directly to the junction box.
● Locate the junction box to allow as much slack as possible between
the junction box and the cooktop so that the cooktop can be moved if
servicing becomes necessary in the future.
● Do not cut the conduit. The length of conduit provided is for
serviceability of the cooktop.
● A UL listed or CSA approved conduit connector must be provided at
each end of the power supply cable (at the cooktop and at the junction
box). A listed conduit connector is already provided at the cooktop.
● If the house has aluminum wiring, follow the procedure below:
1. Connect a section of solid copper wire to the pigtail leads.
2. Connect the aluminum wiring to the added section of copper wire
using special connectors and/or tools designed and UL listed for
joining copper to aluminum.
Follow the electrical connector manufacturer's recommended
procedure. Aluminum/copper connection must conform with local
codes and industry accepted wiring practices.
PRODUCT DIMENSIONS
Model JIC4430
A. 21⁵⁄₁₆" (54.1 cm)
B. 30⁵⁄₁₆" (77.0 cm)
C. 3¹⁄₈" (8.0 cm)
Model KICU509
A. 21⁵⁄₁₆" (54.1 cm)
B. 30³⁄₄" (78.2 cm)
C. 3¹⁄₈" (8.0 cm)
Models JIC4536 and KICU569
A. 21⁵⁄₁₆" (54.1 cm)
B. 36⁵⁄₁₆" (92.0 cm)
C. 3¹⁄₈" (8.0 cm)
Because Whirlpool Corporation policy includes a continuous commitment to improve
our products, we reserve the right to change materials and specifications without notice.
NOTES: After you make the countertop cutout, some installations may require notching
down the base cabinet side walls to clear the cooktop base. To avoid this modification, use
a base cabinet with sidewalls wider than the cutout.
If cabinet has a drawer, a 5¹⁄₈" (13 cm) depth clearance from the countertop to the top of
the drawer (or other obstruction) in base cabinet is required.
Dimensions are for planning purposes only. For complete details, see Installation
Instructions packed with product. Specifications subject to change without notice.
Ref. 501961902036B
4/21/11