Pioneer DVR-108 Installation Instructions

Add to My manuals
2 Pages

advertisement

Pioneer DVR-108 Installation Instructions | Manualzz

D RIVE I NSTALLATION

I N A N I NSTANT

Step 1 – Prepare the Computer

1) Turn OFF the computer and disconnect the power cord.

2) Remove the bezel and the open drive bay cover from the computer’s front panel.

Note: Your computer may be a tower model as shown on the left or a desktop model as shown below. This drive works in either PC model style.

Step 2 – Prepare the Drive

3) Attach slide rails to the drive if required for your drive model.

Slide rails are sold separately through computer retailers.

4) Position the drive close to the open computer bay.

Horizontal Installation Vertical Installation

Step 3 – Connect the Cables

5) Connect the power cable from the computer to the drive.

Pay close attention to the polarity of the cable.

6) Connect the IDE cable to the drive.

Confirm that Pin 1 on the drive corresponds to Pin 1 on the cable.

7) Connect the drive’s audio output to the sound card if one is present.

D RIVE I NSTALLATION

I N A N I NSTANT

Step 4 – Finish the Installation

8) Place the mounting screws in the appropriate holes and tighten by hand.

When mounting screws are loose, vibrations from the spinning disc may cause a ripping sound.

9) Replace the bezel and power ON the computer.

Setting the Jumper For Use in a Master/Slave PC

If you have a Master/Slave type of computer, you probably have two IDE channels, Primary and Secondary. The hard drive is using the Primary IDE channel and any drives are using the Secondary channel. Install this drive as the Master change your older drives or other equipm ent on the Secondary channel to a Slave device.

1) Disconnect the following drive cables in the order listed below.

• Power cable

• IDE cable

• Audio cable

2) Remove the drive from the drive bay.

3) Use your fingers or a tool to move the jumper to the new setting.

4) Return the drive to the drive bay.

5) Reconnect the cables in the reverse order, Audio, IDE then Power.

Jumper: (jumpered = ON; no jumper = OFF)

Set the jumper to select the drive type for your computer.

1

2

3

4

5

MA

SL

CS on Drive set to Master mode on Drive set to Slave mode on Drive set to Cable Select mode

Reserved

Reserved

Master Slave

Setting the Jumper For Use in a Cable-Select PC

Some computer s su pport a dat a e n f your PC uses Cable Select then all devices need to be set to Cable Select as well. Also, the IDE cable must be designed for Cable Select communication.

Simply position the jumper r Cab le Select an d install the drive according to the instructions beginning on the opposite s ide of this paper. No other changes are required when usin g Ca ble Select computers.

Do Not jumper the drive to Cable Select unless your PC uses this method.

advertisement

Related manuals

advertisement