Emprex 52X User`s manual

Add to My manuals
18 Pages

advertisement

Emprex 52X User`s manual | Manualzz

52X DDS CD-RW Drive

Dual Digital Storage

7 in 1 card reader compatibility

User’s Manual

C L A S S 1 L A S E R P R O D U C T

A P P A R E I L A L A S E R D E C L A S S E 1

L A S E R K L A S S E 1

L U O K A N 1 L A S E R L A I T E

P R O D U I T L A S E R

C A T E G O R I E 1

DANGER INVISIBLE LASER RADIATION WHEN OPEN AVOID DIRECT EXPOSURE TO BEAM

VORSICHT INSICHTBARE LASERSTRAHLUNG WENN ABDECKUNG GEÖFFNET NICHT

DEM STRAHL AUSSETSEN

ATTENTION RADIATION DU FAISCEAU LASER INVISIBLE EN CAS D’OUVERTURE.

EVITER TOUTE EXPOSITION AUX RAYONS.

Copyright Statement

It is a criminal offence, under applicable copyright laws, to make unauthorised copies of copyright-protected material, including computer programs, films, broadcasts and sound recordings. This equipment should not be used for such purposes.

FCC Compliance Statement

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

1. this device may not cause harmful interference, and

2. this device must accept any interference received, including interference that may cause undesired operation.

FCC Warning Statement

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can emit radio frequency energy and, if not installed or used in accordance with the instructions, may cause interference to radio communications. However, television reception interference can be determined by turning the equipment off and on. The user is encouraged to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna

• Increase the separation between the equipment and the receiver

• Connect the equipment into an outlet different from that to which the receiver is connected

• Consult the dealer or an experienced radio/TV technician for help.

CAUTION

Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

FOR EUROPE

“The drive is in conformity with the EMC directive and low-voltage directive.”

Table of Contents

INTRODUCTION 1

S

YSTEM

R

EQUIREMENTS

P

ACKAGE

C

ONTENTS

2

2

INSTALLATION 3

H

OST

I

NTERFACE

C

ONNECTIONS

H ARDWARE I NSTALLATION

S OFTWARE I NSTALLATION

Windows Environment

3

4

6

6

CONNECTION & OPERATION

F RONT P ANEL

R

EAR

V

IEW

TECHNICAL DATA

7

7

9

11

52X DDS CD-RW Drive

INTRODUCTION

Thank you for the purchase of this perfect and compact dual digital storage drive with the combination of an IDE CD-ReWritable drive and a USBconnected card reader.

This drive backs up all writing modes and different CD formats. It supports maximum 52x speed writing ability on CD-R discs, 32x speed on CD-RW discs and 52x speed reading performance. Other than that, the built-in 7 in

1 card reader which offers read-write capabilities of 7 memory card types simplifies the process of exchanging data between digital cameras, voice recorders, PDAs, MP3s… and your computer.

With this multi-functional solution and the bundled software package, you can view, archive, or write files/photos/video/music directly from the drive and enjoy the fascinating digital entertainment on your desktop.

Here are some important features:

♦ Easy installation with CD-RW drive of EIDE and card reader of USB

2.0 interface (on-board connection)

♦ 8X, 16X, 24X, 32X, 40X, 48X and 52X writing speed on CD-R media

♦ 4X, 10X, 12X, 16X, 20X, 24X and 32X writing speed on CD-RW media

♦ Adopts “MTKSuperLink” to prevent Buffer Underrun

♦ Supports MultiRead function

♦ Supports writing modes of TAO, DAO, SAO and packet writing

♦ Four-slot integration of the card reader works with CompactFlash,

MicroDrive, Memory Stick, Memory Stick Pro, MultiMediaCard,

Secure Digital, and SmartMedia

♦ Convenient connection with A-Type USB Extension Port on the front panel

1

52X DDS CD-RW Drive

System Requirements

For IBM compatible PCs, the system requirements recommended are as follows:

♦ Pentium II 350MHz above with at least 64MB of memory

♦ Fast and sufficient hard disk space (minimum 200MB for installation,

1GB or more is recommended.)

♦ IDE host interface supporting ATAPI MMC command & USB host interface (if you don’t have USB on-board connection)

♦ Operating system: Microsoft Windows 98SE/ME/2000/XP

Package Contents

♦ 52X DDS CD-RW Drive

♦ Audio cable

♦ Application software disc

♦ Quick Installation Guide

2

INSTALLATION

52X DDS CD-RW Drive

Host Interface Connections

Most current motherboards have two IDE ports (primary and secondary) which can connect two IDE cables. Two IDE cables allow you to connect up to four devices, but it is recommended that you separate IDE ports for your hard disk and your CD-ReWritable drive. This will ensure that your hard disk’s performance and speed won’t be affected by having the CD-

RW drive on the same cable.

Master

Slave

Cable Select

If you connect only one device on the cable, you can set the jumper as

“MASTER” or “SLAVE”.

If you connect two devices (e.g. CD-ROM & CD-RW) on the same cable, set different jumpers for each device (CD-ROM as “MASTER”, CD-RW as

“SLAVE” and vice versa.) The same rule applies to the connection of having your hard disk and another device on the same cable.

Cable Select

Slave

Master

Jumper

3

52X DDS CD-RW Drive

Hardware Installation

1. Turn off the power to the computer system.

2. Disconnect the power cord and all cables from the back of your computer, and then remove the cover of the computer.

3. Insert the drive into one of the vacant 5.25" drive bays and secure it with screws to your PC.

4. Connect one end of the 40-pin IDE cable to the IDE connector of this drive and the other end to the IDE port on your motherboard. Also, connect the power supply cable to the back of the drive.

Audio Out Power In

Digital

Audio Output red edge

Make sure to align and connect the red-edge of the IDE Cable to Pin

1 on the drive.

5. If you have a sound card that can be connected to this drive, you can connect the drive (as Audio-out) and the sound card (as Audio-in) with a 4-pin audio cable.

If your motherboard is integrated with built-in sound system, plug the

4-pin audio cable into the CD-IN connector on the motherboard as

Audio-in.

4

52X DDS CD-RW Drive

6. Connect the USB cable at the back of the drive to the USB header on the computer’s motherboard. The red wire of the cable needs to be plugged into Pin 1 on the board.

This drive supports USB 2.0 and if you connect to USB 1.1 connector, only transfer rate of USB 1.1 will be available.

IDE

Red Wire

USB

Red Wire

Mother

Board

Signal

Red/Vcc

White/D-

Green/D+

Black/Ground

Braided Shield Ground

Error-Proof Pin

Pin#

1 / 6

2 / 7

3 / 8

4 / 9

5

10

USB Header

Error-Proof Pin

If the connection is correct, the lower right LED on the front panel will light green.

7. Re-attach the cover of your computer, and reconnect the power cord and all cables.

5

52X DDS CD-RW Drive

Software Installation

The bundled mastering software gives you the complete solution for making audio/data CDs. With the user-friendly interface, it guides you through the creation and backup of files/photos/video/music from your computer to a recordable compact disc. Combining of the card reader capabilities, no matter you are a novice or an experienced user; you can enrich your digital life with this best recording tool.

Windows Environment

1. Insert the application CD and the installation program will run automatically. Then follow the on-screen procedures.

Or

2. Run:\setup.exe on the application CD.

6

CONNECTION & OPERATION

52X DDS CD-RW Drive

Front Panel

4 5

10

1 6 7 2 3 8 9 11

1. A-Type USB Extension Port

This USB port is Plug-and-Play Ready. Just plug your USB device and the computer will detect automatically.

2. Close/Eject Button

This button opens and closes the disc tray. If the tray is closed, pressing the button will eject it.

3. LED Indicator (the CD-RW drive)

Flashes “green” while verifying or reading a disc.

Flashes “amber” while writing a CD-R/CD-RW disc.

4. Disc Tray

Place the disc in the tray here, and then press the Close/Eject button or lightly push the tray to close it.

7

52X DDS CD-RW Drive

5. Emergency Eject Hole

When the Close/Eject button doesn’t work properly and the disc tray can’t be opened, you can insert a paper clip or a small rod into this hole for manual ejection. Please make sure to power off the system before you do that.

6. Slot for Memory Stick (MS)/Memory Stick Pro (MS Pro)

7. Slot for Secure Digital (SD)/MultiMediaCard (MMC)

8. Slot for Compact Flash (CF) Type I, II/MicroDrive

9. Slot for Smart Media

10. LED Indicator (the Card Reader)

When the data of the memory card is being accessed, the LED flashes red.

11. LED Indicator (the Card Reader)

Once the USB cable is correctly connected, this LED will light green, which means the card slots are ready to use.

NOTE: The front panel is subject to change without notice.

8

Rear View

52X DDS CD-RW Drive

2 3 4 5

6

1. Digital Audio Output Connector

If your sound card has a digital audio IEC958 format connector, you can connect it to this digital audio output connector with a 2-pin audio cable.

2. Analog Audio Output Connector

This connector allows you to connect the drive to your sound card with a 4-pin audio cable.

3. Device Configuration Jumper

Set the jumper to Master, Slave or Cable Select according to your system configuration.

4. IDE Interface Connector

Plug one end of the 40-pin IDE cable here to join the 40-pin IDE connector on the motherboard. The red-edge of the IDE cable must be connected to Pin 1 of each connector.

5. Power Supply Connector

By plugging the computer’s power supply cable here, you can connect the drive and your computer system.

9

52X DDS CD-RW Drive

6. USB Cable

Connect the USB cable to the USB connector on the motherboard.

The red wire of the cable needs to be plugged into Pin 1 on the board.

10

TECHNICAL DATA

52X DDS CD-RW Drive

Form factor

Writing speed

Writing modes

Digital Media

CD format support

Transfer rate

CD-RW Drive

Card Reader

Data buffer

Card Reader: USB 2.0

5.25" Half Height

CD-R:

8X/16X/24X/32X/40X/48X/52X

CD-RW:

4X/10X/12X/16X/20X/24X/32X

TAO (Track at once), DAO (Disc

At Once), SAO (Session at once),

Multi-session, Packet Writing

CompactFlash, MicroDrive, Memory

Stick, Memory Stick Pro, SmartMedia,

MultiMediaCard, and Secure Digital

CD-DA, CD-ROM, CD-ROM XA, CD-I,

Photo CD, CD-TEXT, Video CD, CD-

Extra, CD-R, CD-RW, CD-UDF

Read:

CD-ROM/CD-R:

7800KB/s (up to 52X)

CD-RW: 4800KB/s (up to 32X)

Write:

CD-R 7800KB/s (up to 52X)

CD-RW 4800KB/s (up to 32X)

480Mb/s (USB 2.0)

2MB

11

52X DDS CD-RW Drive

Access time

Disc loading

Audio output level

Power

Dimensions

Height

Width

Depth

Weight

Disc Specification

Capacity

120mm disc: 74min

90ms at ⅓ stroke(52X CD-ROM)

180ms at full stroke(52X CD-ROM)

200ms at full stroke (32X CD-RW)

Tray (motorised), Dust Sealed

Line out = 0.6 ± 10%Vrms

5 VDC & 12VDC

Card Reader power directly from computer power supply through USB connection

41.8 ± 0.2

mm

148.6 ± 0.2 mm

193.3 ± 0.3mm

1 kg

650MBytes Mode-1

80mm disc: 18min 158Mbytes Mode-1

12

Environment

Temperature

Operating

Non-operating

Humidity

Operating

Non-operating

52X DDS CD-RW Drive

5°C to 45°C

-20°C to 60°C

8% ~ 80%RH

5% ~ 95%RH

13

3100552210

Version 1.2

April 2004

advertisement

Related manuals

Download PDF

advertisement