Product information Pro-Ject Amp Box Mono

Product information  Pro-Ject Amp Box Mono
Product information
Pro-Ject Amp Box Mono
Mono power amp
Good sound from sound technology
Metal case shields the electronics from vibrational and electromagnetic interference
Bi-Phase PWM-circuit (Pulse Width Modulation)
Gold plated RCA/Phono sockets and loudspeaker terminals
Outboard power supply included
Small size allows easy placement
Pro-Ject Audio digital amplifiers achieve 80% energy efficiency
The Amp Box Mono can be switched on & off remotely via a trigger signal. A 45cm long power-on cable
is supplied for this purpose
For bi- ore tri amplification use, the preamplifier signal and the remote power-on signal can be relayed to
further units
Technical specifications
Power output:
Frequency response:
Noise floor:
Pre in:
Input sensitivity:
Input impedance:
Pre out:
2 x 28W/40W at 8ohms /4ohms
5Hz - 20kHz / + 0dB, - 0,5dB
> -100dB / A weighted
< 0,05% / 10W
1 RCA/Phono socket
1 RCA/Phono socket
Speaker connector:
4mm ∅ banana plugs, spade connectors or naked wire
12V DC switching voltage
Trigger in and out:
Outboard power supply:
Power consumption:
Dimensions W x H x D (D with sockets):
2-pole co-axial ∅ 2,5mm jack
20V/3A DC (peak 7A DC), suitable for your country's mains supply
20V/3A DC
103 x 36 x 103 (122)mm
670g without power supply
The manufacturer reserves the right to alter the technical specifications without notice.
Available in silver or black finish
Pro-Ject Audio Systems is a registered trademark of Heinz Lichtenegger
1050 Vienna · Margareten Road 98 · Tel. +43(0)15448580 · Fax. +43(0)15456697 · © Heinz Lichtenegger · Revision 1.6.10
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF