Regulus TZT 63 Bathroom towel radiator kit User manual

Below you will find brief information for Bathroom towel radiator kit TZT 63. The TZT 63 is a plug-in room thermostat that controls the temperature of a local heater. It can be used for bathroom towel radiators connected to a traditional hydronic heating system. The thermostat has a timer function that allows you to set the heating on for a specified period of time. This is useful for heating the bathroom in the morning or evening. The thermostat also has a frost protection mode that prevents the room from freezing in the winter.

PDF Download
Document
Bathroom Towel Radiator Kit TZT 63 User Manual | Manualzz

Advertisement

Advertisement

Advertisement

Key features

  • Plug-in room thermostat
  • Timer function
  • Frost protection mode
  • Temperature control for local heater
  • Control for bathroom towel radiators
  • Heating element with thermal reset
  • Safety cutoff for overheating

Frequently asked questions

To set the thermostat, press the up ▲ or down ▼ key to adjust the temperature. To save the value, press the OK () key. The display will show "On" and the ambient temperature.

To use the timer, press the OK () key. The remaining time will be displayed on the LCD together with a flame symbol (heating on). To set a new timer value, press the up ▲ or down ▼ key. The timer time starts flashing. The desired timer value can be set by pressing up ▲ or down ▼ key between 15 minutes and 5 hours, in 15 minute steps. Then press OK (). After one more pressing () the display will show the timer and the flame symbol again (heating on). The preset timer value will be modified in case the appliance is in the thermostat mode. When in timer mode, the timer value will be updated only after pressing twice the key OK (). Countdown starts. When the preset time expires, timer mode ends and the appliance returns to the thermostat mode. The display shows ”On” and the ambient temperature again.

The heating element shall be installed into a radiator according to the relevant safety and technical rules and standards, following the manufacturer‘s recommendations, and the installation shall be done by a qualified staff.
Preparing document for printing…
0%