User manual | 12 05-13

12 05-13
1
12 05-13
SUBJECT
DATE
Oil Filter
December 2013
Additions, Revisions, or Updates
Publication Number / Title
Platform
Section Title
Change
DDC-SVC-MAN-0081
DD Platform
DDC-SVC-MAN-0181
EuroIV
Replacement of the Oil
Filter
Added instructions to inspect the oil filter stand pipe and bypass
valve.
All information subject to change without notice.
12 05-13 Copyright © 2014 DETROIT DIESEL CORPORATION
3
2 Replacement of the Oil Filter
2
Replacement of the Oil Filter
Remove as follows:
1. Clean any debris on the filter housing around the oil filter cap.
2. Using a 36-mm socket, unscrew the oil filter cap (1) and filter (3), and allow the oil to drain into the housing (4). After
draining is complete, remove the assembly from the housing (4).
NOTE: For Setra Bus, when removing the filter, separate the cap from the filter before pulling out of the module.
Remove as two separate components.
NOTE: Use care to prevent foreign objects from entering the filter housing.
NOTE: Do not service the air filter with the oil filter cap removed.
3. Remove the filter element by pressing and twisting the side and detaching it from the cap. Discard the filter element.
4. Remove the oil filter O-ring and discard. Lightly coat a new O-ring with clean engine oil and install it on the original
filter cap.
5. Check the filter housing for any debris and remove if necessary.
6. Inspect the oil filter stand pipe (2) and oil bypass valve (3). If damaged or oil bypass valve is missing (1) contact the
Customer Support Center.
4
All information subject to change without notice.
Copyright © 2014 DETROIT DIESEL CORPORATION 12 05-13
12 05-13
7. Insert a new filter element and the cap assembly into the housing. Torque the cap to 40 to 50 N·m (30 to 37 lb·ft).
All information subject to change without notice.
12 05-13 Copyright © 2014 DETROIT DIESEL CORPORATION
5

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project