Husky Liners Installation Instructions 5618

Husky Liners Installation Instructions 5618
PN: 5618
DODGE RAM – WITH FENDER FLARES
FRONT MUD GUARD - INSTALLATION INSTRUCTIONS
Please read instructions thoroughly before installation.
Tools Required
Package Contents
• 10mm Wrench or Socket
• Driver & passenger side front mud guards
• Paint Protection Film (1 set)
• Instruction sheet
PAINT PROTECTION FILM - INSTALLATION
NOTE: The Paint Protection Film is a precut template of film used to protect the mud guard mounting
surfaces of your fenders against wear. The templates (left and right side) can be removed from the
backing liner by folding the liner at the center cut of the template, separating the film sides and
peeling the film templates from the backing liner.
1. Position mud guard on fender to indicate placement location of paint protection film.
2. Clean the placement area of fender with a clean cotton cloth and a petroleum distillate based cleaner such
as DuPont Prep-Sol Brand Solvent Cleaner or 3M Brand Adhesive Cleaner and dry.
3. Mix a wetting solution of 1 pint of water with 4 drops of liquid dishwashing detergent.
4. Mark correct position of film by placing mud guard against fender.
5. Remove protection film from liner and flood adhesive side of film with wetting solution (use a spray bottle
or sponge).
6. Thoroughly wet film placement location of fender with wetting solution.
7. Position the adhesive side of film on fender and flood with wetting solution.
8. Check location of film with mud guard and reposition as necessary.
9. Using a sponge, squeegee any air bubbles and wrinkles from film.
10. Allow film to dry before installing mud guard.
Page 1 of 2
5618 Dodge Ram with Flares Front Mud Guards
Rev: 0
PN: 5618
MUD GUARD INSTALLATION
NOTE: Turn wheels all the way left or right for easier installation. It may be necessary to remove the
wheels before mud guard installation.
1. Remove the existing fasteners from locations A and b (Figure 1).
2. Attach the mud guard at locations A and B with the existing fasteners. Check the mud guard fit and
appearance before tightening.
Figure 1
PAINTING INSTRUCTIONS
1.
2.
3.
4.
Clean mud guard with soap and water to remove dirt and other contaminates.
Sand painting surface with 320 grit sand paper.
Apply a coating of flexible primer-adhesion promoter.
Apply a flexible paint as directed by the paint manufacturer.
Page 2 of 2
5618 Dodge Ram with Flares Front Mud Guards
Rev: 0
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement