STCH EL Stand Alone FW Programmer FW Install Guide

STCH EL Stand Alone FW Programmer FW Install Guide
OLIMEX MSP430
MSP430-PROGRAMMER FIRMARE INSTALLATION
Step 1: Install the software
•
OLIMEX MSP430-PROGRAMMER
PROGRAMMER - GUI 1.3.0.4_CLI 2.0.1.2_DLL1.0.4.2/ 17.11.2011 freeware stand alone software which allows you to program MSP430 devices
Step 2: Replace the 3 dll and 1 ini files in the Olimex directory with the files provided by Stanley
Step 3: Install the Drivers to the already existing Olimex drivers folder
•
Windows drivers + MSP430
MSP430-JTAG-ISO-MK2 firmware version 2.007
The software and drivers can both be found here if the links above do not work:
https://www.olimex.com/Products/MSP430/JTAG/MSP430
https://www.olimex.com/Products/MSP430/JTAG/MSP430-JTAG-ISO-MK2/
Step 4: Run USBXpressInstller.exe found in the Olimex folder
Step 5: If your Jtag Programmer is not already plugged in via U
USB
SB then make that connection now.
NOTE: You will also want to have your programmer plugged into daughter card and the daughter should
be plugged into an EL Lockset. If these connections are not made you will get an error “Cannont Connect
to Device”
Step 6: If prompted to install new hardware when plugging in allow it to find the drivers you just
installed.
Step 7: Looking at your programmer screen make sure the arrow is pointing to “Debugger” press the
right arrow on the pad.
Step 8: Your screen should looks
oks similar to this:
STANLEY Security-SMS Technical
echnical Support 1-800-392-5209
1
OLIMEX MSP430
MSP430-PROGRAMMER FIRMARE INSTALLATION
Step 9: Open the Olimex Program
Step 10: Find “MSP430F5340” in the drop down list and select it
Step 11: UNCHECK all “data memory” boxes and the one “READ” box next to “program memory” also
CHECK “SpyBiWire” Box (see green arrows). Leave everything else at default.
STANLEY Security-SMS Technical
echnical Support 1-800-392-5209
1
OLIMEX MSP430
MSP430-PROGRAMMER FIRMARE INSTALLATION
Step 12: Click “Blank Check” within the MSP Programmer application (see green arrow)
Step 13: You will see the following screen if it says NOT blank on both Program and Data memory then
the new JTag device has the new firmware uploaded. --- Click OK
Now see “Programming Firmware into your EL Lock”
STANLEY Security-SMS Technical
echnical Support 1-800-392-5209
1
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising