Dwyer DPG-100, DPG-102, DPG-103, DPG-104, DPG-105, DPG-106, DPG-107, DPG-108, DPG-109, DPG-110, DPG-111, DPG-120, DPG-121, DPG-122, DPG-123, DPG-124 Digital Pressure Gage Instructions

Below you will find brief information for Digital Pressure Gage DPG-100, Digital Pressure Gage DPG-102, Digital Pressure Gage DPG-103, Digital Pressure Gage DPG-104, Digital Pressure Gage DPG-105, Digital Pressure Gage DPG-106, Digital Pressure Gage DPG-107, Digital Pressure Gage DPG-108, Digital Pressure Gage DPG-109. The Series DPG-100 Digital Pressure Gage has a precise +/- 0.25% full scale accuracy. The 4 digit digital display will reduce the potential for errors in readings by eliminating parallax error commonly produced with analog gages. The DPG-100 is packaged in a durable extruded aluminum case designed to meet NEMA 4/4X. The unit is battery powered and has an auto-shut off to conserve battery life. A four button key pad allows easy access to features without the need to work through complex menus or difficult key combinations. These features include backlight, peak and valley, auto zero and conversion of the pressure units. Readings may be converted to various engineering units. See reverse page for available units. When installing gage always use 1˝ hex at the base of the housing to tighten the gage to a mating fitting. Do not apply wrench to housing.

PDF Download
Document
Dwyer DPG-100 Digital Pressure Gage Instructions | Manualzz

Advertisement

Advertisement

Advertisement

Key features

  • Precise accuracy
  • Digital display
  • Durable housing
  • Battery powered
  • Auto-shut off
  • Four button keypad
  • Backlight
  • Peak and valley
  • Auto zero
  • Unit conversion

Frequently asked questions

With no pressure applied to the gage, press and hold the ZERO button until the display flashes. If the gage will not zero, then the gage is no longer meeting specified accuracy and should be sent back to the factory for recalibration. Note: The gage is not to be zeroed while pressure is applied.

Press the UNIT button to change units on the gage. Not all units are available for each range, please refer to the model/range chart located below for available units.

Remove the three screws on the backplate. Lift the backplate off by hand. Replace batteries per polarity indicators. To reassemble, ensure the O-Ring seats into the housing evenly and press until seated completely. Replace screws.
Preparing document for printing…
0%