Bullard ADP20 Datasheet

Bullard ADP20 Datasheet
netzerotools.com
Bullard ADP20 Free Ambient Air Driven Pump
ADP20 Air-Driven
Free-Air Pump
®
The only air-driven ambient air pump that can
power a climate control device.
The convenient air-driven ADP20
Free-Air pump is an ideal alternate air
source for supplied-air respirator users.
The ADP20 is the best choice for
users working in locations without an
electrical power source (but compressed
air is available). Alternatively, the
ADP20 is also ideal for potentially
explosive work environments that
would require a costly, explosion-proof
electrical motor.
Expensive carbon monoxide alarms
may not be required as air from the
The Frigitron® 2000 series air
conditioner can cool incoming
air by as much as 20°F (11°C).
The ADP20 pump does not
require CO monitors, alarms
or calibration procedures.
drive compressor is not transferred to
the worker. Rather, the pump should
be located at a source of clean, fresh,
ambient air which is filtered to remove
certain particulates and then transferred to the worker. Compressed air
at a minimum volume of 85 cfm at 95
psig (2407 lpm at 655 kPa) is used
only as an energy source.
The powerful ADP20 pump is not only
versatile but allows the use of a Bullard
personal air conditioner to provide
additional worker comfort and productivity. The pump provides 30 cfm of air
operating at 5 psig (850 lpm at 34.5
kPa). Maximum pressure output is 25
psig (172.4 kPa).
Used without a personal air conditioner, the ADP20 pump can supply
a continuous flow of air to up to six
workers wearing supplied-air masktype respirators or up to four workers
wearing supplied-air hood-style
respirators.
For enhanced worker comfort, the
ADP20 can supply air to one worker
using the Bullard Frigitron® 2000
Series personal air conditioner in
conjunction with a Bullard CC20 or 88
Series hood-style respirator. The
Frigitron can lower the temperature of
the air supplied to the respirator hood
by as much as 20°F (11°C) resulting
in a more comfortable and productive
worker.
netzerotools.com
netzerotools.com
ADP20 Air-Driven Ambient Air Pump Specifications
AIR FLOW: 30 cfm at 5 psig
(850 lpm at 34.5 kPa)
PUMP SPECIFICATION TABLE
Pump
Model No.
ADP20
ADP20 with
Frigitron 2000
Series Air
Conditioner
Maximum
Number of Respirators
Maximum Outlet
Air Pressure*
Hood
Four
Full/Half
Six
25 psig (172.4 kPa)
One
None
25 psig (172.4 kPa)
The air motor requires a continuous
supply of 85 cfm air volume at 95 psig
(2407 lpm at 655 kPa) for optimum
performance.
DIMENSIONS: 12 1/8” (31.3 cm) Wide
x 25” (63.5 cm) Long x 15” (38.1 cm)
High (41 1/2” (105.4 cm) High with Air
Intake installed)
INLET FILTER: Medium efficiency,
keeps particulates larger than 25
microns out of the air supply.
NOTE: Supplied-air respirators used
with this ambient air pump must be
MSHA/NIOSH approved to operate at
25 psig (172.4 kPa) or less. See
respirator owner’s manual for
recommended air pressure
requirements.
OUTLET FILTER: Carbofine with
activated carbon.
*USE ONLY SUPPLIED-AIR RESPIRATORS THAT ARE APPROVED BY
MSHA/NIOSH TO OPERATE AT 25 PSIG (172.4 kPa) OR LESS.
WEIGHT: 90 lbs. (40.8 kg)
ORDERING INFORMATION
Cat. No.
Description
23611
S17101
244852
15922
Inlet Filter
Outlet filter cartridge
Outlet filter jar
Pump service kit (Includes four carbon vanes, 23611 inlet filter and
S17101 outlet filter cartridge)
Air motor service kit (Includes four carbon vanes, motor bearings,
vane springs and seal
Loctite® Safety Solvent, 12 oz. (340 g) aerosol can
Conversion kit. Includes parts and instructions to convert ADP16 or
ADP3CA pumps to ADP20.
Pressure gauge, motor,0-230psig (0-1379 kPa)
Pressure gauge, pump, 0-35 psig (0-207 kPa)
Quick-disconnect coupler adaptor. Converts pump’s quick-disconnect
coupler to double 3/8” femaleNPT
Quick-disconnect coupler adaptor. Converts pump’s quick-disconnect
coupler toasingle3/8”femaleNPT
Quick-disconnect coupler splitter/adaptor, converts pump’s single
outlet to a double 1/2” Industrial Interchange coupler (one flowthrough, one shut-off)
Remote inlet air hose kit, 50 feet (15.2 m) (one per pump)
Remote extension hose kit, 50 feet (15.2 m) (five per pump maximum)
17761
S17931
21052
S09853
S16222
V22
V23
V24
V50IN
V50EX
Distributed by:
WARNING
The ADP20 Free-Air® pump DOES NOT
filter out carbon monoxide or other harmful
or deadly gases. Only climate control
devices manufactured by E.D. Bullard
Company should be used with Bullard
respirators. Substituting other climatecontrol tubes will expose the user to life
threatening conditions, diseases, or death.
Inlet air filter must be located where clean,
breathable air is assured at all times, away
from the source of any contaminants.
E.D. Bullard Company products are manufactured to exacting specifications. Any
alteration or modification of these products
by the user may adversely affect product
performance. This data sheet is in summary
form only for easy reference. Refer to
labels, instructions, or other literature
accompanying the product for complete
details regarding use, maintenance,
warnings, performance, complete specifications, instructions and precautions.
netzerotools.com
23611
S17101
S09853
S16222
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement