Methven warrants this product against manufacturing defects and that it is suitable for use under the operating conditions specified in this instruction sheet.
For your warranty please refer to www.methven.com or call Customer Service
New Zealand
0800 804 222
Australia
1300 638 483
UK
0800 195 1602
436710 Issue C
WAIPORI SINK MIXER
INSTALLATION GUIDE
TECHNICAL SPECIFICATIONS
Operating Pressure:
Min 35kPa, Max 1000kPa.
Recommended 35kPa - 500kPa.
Recommended installation of a pressure limiting valve if supply exceeds 500kPa.
Operating Temperature:
Hot: Max 80°C.
Cold: Min 5°C.
NB: New Zealand Building Code Clause G12 -
Water Supplies specifies all outlets used primarily for personal hygiene shall deliver water at a safe temperature.
Inlet Connections:
All ½" BSP.
IMPORTANT
Please read all of the instructions before installation
This mixer is designed for equal and unequal pressure systems.
All pipework must be thoroughly flushed prior to the installation of the mixer. In-line filters must be fitted on both hot and cold supplies to prevent foreign particles damaging the ceramic cartridge.
Stream shaper
Base ring
O-ring
Twin Stud fixing system
Clamp plate
Mounting nuts
Flexible inlet hose: cold hot
Equal Low Pressure and Unequal Pressure
Installations
Remove flow restricted (yellow) stream shaper using cache key.
Replace with un-restricted (white) Slim HC stream straightner.
Max 40mm
Hot
CORRECT
INCORRECT
DO NOT STRETCH OR TWIST HOSES
DO NOT CRUSH
HOSE OR
SWAGED ENDS
R35mm Min
Cold
Non Return Nipple
Ø35mm min
Ø42mm max
