Quick Start Guide - WL2110KIT
www.lorextechnology.com
WL2110KIT: Installation Instructions
Step 1 of 2: Set up the antenna and wireless receiver
1. Connect the extension cable (included with the antenna) to the SMA connector on the
wireless receiver as shown below.
SMA connector Extension cable
2. Connect the other end of the extension cable to the antenna.
3. Connect the power adapter to the wireless receiver’s DC port. Connect the wireless receiver
to a DVR/monitor.
Power connector
Final Result
Extension
cable
Antenna
Wireless Receiver
DVR /
Monitor
NOTE: For antenna mounting instructions, refer to the antenna installation guide.
Step 2 of 2: Pair the camera and receiver
To pair the camera to the receiver:
1. Power on the camera and receiver.
2. On the receiver, press and hold the Pairing button for 5 seconds to activate the pairing
function.
• The on-screen displays informs you that you have 30 seconds to press the Pair button on the
camera.
Pairing button
3. Press and hold the Pair button underneath the antenna on the back of the camera.
• You must press the Pair button on the camera within 30 seconds of pressing the Pair button
on the Wireless Receiver. If pairing is successful, live video from the camera will immediately
appear on the monitor.
Pair button
Copyright © 2011 Lorex Technology
2
WL2110KIT_QSG_EN_R1
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement