CHANNEL VISION
Limited Warranty
C hannel Vision Technology will repair or replace any defect in material or workmanship which occurs during normal use of this product with new or rebuilt parts, free of charge in the USA, for two years from the date of original purchase. This is a no hassle warranty with no mail in warranty card needed. This warranty does not cover damages in shipment, failures caused by other products not supplied by
Channel Vision Technology, or failures due to accident, misuse, abuse, or alteration of the equipment. This warranty is extended only to the original purchaser, and a purchase receipt, invoice, or other proof of original purchase date will be required before warranty repairs are provided.
Mail in service can be obtained during the warranty period by calling
(800) 840-0288 toll free. A Return Authorization number must be obtained in advance and can be marked on the outside of the shipping carton.
This warranty gives you specific legal rights and you may have other rights (which vary from state to state). If a problem with this product develops during or after the warranty period, please contact Channel
Vision Technology, your dealer or any factory-authorized service center.
500-040
C
Central
ISION
TM
Model C-0432
Phone distribution module
234 F
ISCHER
A
VENUE
• C
OSTA
M
ESA
, CA 92626
(714) 424-6500 • (800) 840-0288 • (714) 424-6510 fax www.channelvision.com • email: [email protected]
© 2004, CHANNEL VISION™
From
Telephone Company
Model C-0432
Telephone distribution module
INPUT
SERVICE
OUTPUT
(RJ31X to security panel)
Switch enables line 1 interrupt for security
C
Central TM
Telephone
C-0432
G-Kit 5
(wall plate kit)
Installation:
Punch down as many as 4 incoming telephone lines on the input 110 punch-down as shown. Use a 110 punch-down tool to seat and trim all wires
Note position of cutter
2
Connect any of the telephone outputs to wall plates in each room (see diagram).
Using the service jack:
This jack is used to send dial tone to an alarm panel and then return dial tone the phone distribution system on a single 8 position plug.
The center pair (blue and blue white) delivery dial to the alarm system. Dial tone returns on the outer conductors
(brown and green white*)
*Color code references assume the use of TIA
568A color scheme.
To
Alarm
System
T
R
1 2 3 4 5 6 7 8
Miniature
8 Position
Plug
1 2 3 4 5 6 7 8
R1 R T T1
RJ31X wiring schematic
R1
T1
From
Alarm
System
Features:
Compact Design
Simple connections
Line 1 interrupt for security systems
Telephone distribution to 8 locations
Loop out connections for easy expansion
Specifications:
Telco inputs:
Loop outputs:
110 connectors:
Dimensions:
2 (1-RJ45 and 1-110)
2 (1-RJ45 and 1-110)
10
4.0”L x 6.38” W x 1.75” D
Specifications subject to change without notice.
3
