WARRANTY CERTIFICATE RAUTITAN System

WARRANTY CERTIFICATE RAUTITAN System
WARRANTY CERTIFICATE
RAUTITAN System
Project name:
Project address:
Building owner:
We hereby confirm that the REHAU installation system of RAUTITAN pipes
and compression sleeve fittings has been installed and commissioned
in the referenced building project in accordance with the relevant codes
and standards and instructions issued by REHAU for the Australia and
New Zealand markets.
Installation contractor:
Consulting engineer:
Screed or slab-laying company:
(Underfloor Heating)
Place, Date Pressure test completed on:
System commissioned on:
Stamp and signature of installation contractor
REHAU shall grant this warranty to the installation contractor in the event
that the owner of the building successfully asserts any claim against the
installation contractor. This warranty shall be valid only if completed in
full and signed by the installation contractor.
REHAU warrants for a period of 25 years the supply of new RAUTITAN
pipes and fittings free of charge to which damage has occured. In
addition to that REHAU assumes warranty liability within the first 10
years from the date of purchase up to an amount of AUD$200,000 per
installation.
The following warranty conditions apply.
inspect the damage within a maximum period of eight days after the damage
1. Scope of warranty
1.1 We guarantee that RAUTITAN pipes and compression sleeve fittings (products) are
produced in accordance with ISO 9001 Quality Management procedures and are
manufactured according to Australian and New Zealand Standards.
1.2 REHAU guarantees the quality of its products and that they are free of manufacturing defects for the period of warranty.
occurs and prior to the execution of any remedial measures. Failure to comply with
this condition will result in the loss of warranty cover.
2.8 Any measures undertaken by REHAU in investigating a claim or in the way of
damage mitigation shall not constitute recognition of liability. Negotiations on the
payment of damages shall under no circumstances be understood as a waiver of
the right to show that the notification of damage required under 2.7 was not given
1.3 This warranty covers faults in the products due to manufacturing defects within 25
years from the date of purchase. After inspection by REHAU, defective products will
be replaced or repaired with equivalent goods free of charge.
in due time, was unfounded or in any other way influenced.
2.9 REHAU shall reserve the right to engage the services of qualified companies of its
1.4 In addition, if product is found to be defective due to a manufacturing fault, REHAU
assumes warranty and liability within the first 10 years from the date of purchase
up to an amount of AUD$200,000 per installation. REHAU shall grant this warranty
to the installation contractor in the event that the owner of the building successfully
asserts any claim against the installation contractor for direct losses suffered or
incurred by the owner of a building as a result of any defective products.
The payment of damages for loss of use, operational downtimes and system
depreciation as well as any other indirect consequential claim for losses shall be
excluded.
own choice to perform any necessary remedial measures.
3.Exclusions
To the fullest extent permitted by law, REHAU excludes all liability for damage or
injury to any person, damage to any property, and any indirect consequential or
other loss or damage.
4.Claim Procedure
Contact the distributor or local REHAU sales office where the product was
purchased from.
1.5 Pipes installed in more than one building under one contract shall be regarded as
one installation.
Our goods come with guarantees that cannot be excluded under the Australian
Consumer Law. You are entitled to a replacement or refund for a major failure and
1.6 Any warranty claim made during the warranty period shall not extend the overall
period of warranty coverage.
for compensation for any other reasonably foreseeable loss or damage. You are
also entitled to have the goods repaired or replaced if the goods fail to be of acceptable quality and the failure does not amount to a major failure.
2.Conditions
2.1 The warranty shall only cover claims for damage due to a fault in the manufacture
of the product.
Under New Zealand Consumer Law, the Consumer Guarantees Act 1993 (“CGA”),
the Fair Trading Act 1986 (“FTA”) and other statutes may impose warranties, conditions and obligations on us which cannot by law (or which can only to a limited
2.2 The warranty will only be valid if the warranty certificate is fully completed and
signed by the installation contractor.
2.3 In the event of a warranty claim being made, the party entitled to warranty cover
must present the proof of purchase including purchase date.
extent by law) be excluded. This warranty is in addition to any rights that you may
have under those statutes.
Other than as expressly provided by this warranty, to the extent permitted by law,
we exclude all such imposed warranties, conditions or obligations and exclude any
warranty, condition or obligation imposed by law, equity or otherwise. Where you
2.4 This guarantee is not valid if non REHAU components (pipe or fittings) have been
installed or if the installation has not been carried out with the REHAU compression
sleeve fitting tool.
acquire the goods from us for the purposes of a business:
(a) the parties acknowledge and agree that:
2.5 The system must be installed by a competent and licensed contractor. Any damage
caused by normal wear and tear, unsuitable or improper use, external influences
(e.g. chemicals, detergents, holes inadvertently drilled in pipework, etc.) as well as
incorrect or faulty assembly/installation shall be excluded from the warranty.
2.6 The installation contactor must show that the design, installation, commissioning
and operation was in accordance with the relevant codes and standards as well as
the instructions and technical guidelines issued by REHAU for the Australian and
New Zealand markets.
(i)
you are acquiring the goods covered by this guarantee for the purposes of a business in terms of sections 2 and 43(2) of the CGA;
(ii)
the goods are both supplied and acquired in trade for the purposes of the FTA and the parties agree to contract out of sections 9 (Misleading and deceptive conduct generally), 12A (Unsubstantiated representations) and 13 (False and misleading representations); and
(b) you agree that all warranties, conditions and other terms implied by the CGA or
sections 9, 12A and 13 of the FTA or any other statute or common law are excluded from these terms to the fullest extent permitted by law.
2.7 In the event of a claim, REHAU must immediately be given the opportunity to
REHAU AUSTRALIA
REHAU Pty Ltd
Suite 1.02, Level 1
8 Parkview Drive,
Sydney Olympic Park, NSW 2127, Australia
REHAU NEW ZEALAND
REHAU Limited
60B Cryers Road
East Tamaki
Auckland 2013, New Zealand
Phone: 1300 768033
Fax: 1300 760665
Email: [email protected]
Phone: 09 272 2264
Fax: 09 272 2265
Email: [email protected]m
www.rehau.com
ANZ014 BT 10.2015
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement