- No category
advertisement
ER30G, ER30GI
Document # PG05-001
30” wide, Epicure
All Gas Range
Electrical Circuit required
120 Vac, 60 Hz, 15 Amps., dedicated, grounded
Total Connected
Load
4.0 Amps. @ 120 Vac,
60 Hz
ELEctRIcAL REqUIREmENts
®
Revised 05/25/10 Page 1/3
PLANNING
GUIDE
•
•
warning
Observe all governing codes and ordinances during planning and installation. Contact your local building department for further information.
This appliance must be installed in accordance with the accompanying installation instructions.
All tolerances ±1/16” (±1.6mm) unless otherwise noted.
45 9/16” (1157mm)
28 9/16” (725mm)
27 1/16” (687mm)
26 1/8” (664mm)
24” (610mm)
1 1/8” (29mm)
Front of open door
Front of handle
Front edge of bullnose
Front panel
Rear of front panel
Backguard thickness
NOTE: Neither model is compatible with a raised vent.
1 9/16”
(40mm)
Product width:
29 7/8” (759mm)
Grates extend
1” above trim
9” (229mm)
Backguard***
ER30GI:
2” (51mm)
Partial stainless steel side panel
3” (76mm)
ER30G:
Full stainless steel side panels
3” (76mm)
Backguard***
6” (152mm)
Backguard*
35”
(889mm) to
37 1/8”
(943mm)
1 3/4” (44mm) Backguard**
* Standard on model ER30G
Optional on model ER30GI, NOT compatible with self-rimming installations
** Standard on model ER30GI
Optional on model ER30G
*** Optional on both models, NOT compatible with self-rimming installations
ER30G is designed for freestanding installations. ER30GI is designed for installation in a recessed cabinet or island. ER30G is
NOT equipped for self-rimming installation.
ER30G/ER30GI
OvERALL DEPth DImENsIONs - sIDE vIEw
Specifications subject to change without notice.
Install all appliances according to accompanying installation instructions.
www.Dacor.com Phone: (800) 793-0093
5.1
Document # PG05-001
B
ER30G, ER30GI
30” wide, Epicure
®
All Gas Range
Revised 05/25/10 Page 2/3
PLANNING
GUIDE
All tolerances +1/16” -0 (+1.6mm, 0) unless otherwise noted.
a* B c
30 1/16” (764mm)
30” (762mm) Minimum
36” (914mm) Recommended
37 1/8” (943mm)
Maximum
* See the cutout dimensions below for self-rimming installations nOTE: Self-rimming kit is included with model Er30gi.
The self-rimming kit allows the trim to overlap the counter top on the sides and back.
13” (330mm)
Max.
4
18” (457mm)
Min.
1, 4
Non-combustible surface along back wall recommended
30” (762mm)
Min.
1 A
Top of finished counter
10” (254mm Min.
to combustible side walls above the range
(both sides)
Note 2
C
Suggested location of utilities 3
1 Vertical to combustible surface from range grate level
2 Cabinet/countertop depth is at discretion of customer but cabinet face SHALL NOT protrude further than rear of front panel. See product dimesions.
3 Consult local code for exact location requirements.
4 Not applicable for cabinets more than a horizontal distance of 10” (254mm) from the edge of the range.
sLIDE-IN cUtOUt DImENsIONs
10” Min. (254mm) to any combustibles above counter both sides non comubustible rear wall recommended
10” Min. (254mm) to any combustibles above counter both sides rear wall or countertop edge
3/4” Min. (19mm)
Countertop overhang
24”
(610mm) below countertop
Cabinet face below countertop overhang to width of cabinets
Countertop Height: Min: 34 3/4” (883mm)
Max: 36 7/8” (937mm)
Countertop Thickness: Max: 1 5/8” (41mm)
Countertop overhang
2 1/8” (54mm) Max. sELf-RImmING cUtOUt DImENsIONs - cAbINEt DEPth ExActLY 24 INchEs
(ER30GI ONLY)
Specifications subject to change without notice.
Install all appliances according to accompanying installation instructions.
29 1/4” (743mm) countertop opening cabinet opening below countertop
Cabinet face below countertop
Notch countertop overhang to width of cabinets
Countertop Height: Min: 34 3/4” (883mm)
Max: 36 7/8” (937mm)
Countertop Thickness: Max: 1 5/8” (41mm)
24 1/8”
(613mm)
Countertop overhang
2 1/8” (54mm) Max. sELf-RImmING cUtOUt DImENsIONs - cAbINEt DEPth GREAtER thAN 24 INchEs
(ER30GI ONLY) www.Dacor.com Phone: (800) 793-0093
5.2
Document # PG05-001
ER30G, ER30GI
30” wide, Epicure
®
All Gas Range
Revised 05/25/10 Page 3/3
PLANNING
GUIDE
12 1/2”
(318 mm) to
14 5/8”
(371 mm)
2 5/8”
(67 mm) bAck Of RANGE gas
Type
Natural
LP gaS SUPPLY PrESSUrE rEQUirEMEnTS
Manifold
Pressure* (wC)
Min. gas Supply
Pressure (wC)
Max. input
Pressure
5”
10”
6”
11”
1/2 p.s.i.
1/2 p.s.i.
iMPOrTanT: The information above is for reference only. If the above data does not agree with the product data label, use the data on the product data label on top of the kick plate below the door (remove the door according to the installation instructions to view it).
The gas connection is located on the back of the unit as shown. Use a
1/2" male NPT to connect to the regulator.
CL
12” (305mm)
2 1/2”
(64mm)
3 1/2”
(89mm)
CL
1” (25mm)
UtILItY cLEARANcE bEhIND RANGE
Specifications subject to change without notice.
Install all appliances according to accompanying installation instructions.
www.Dacor.com Phone: (800) 793-0093
5.3
advertisement
* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project