Shimano HG/IG/UG CN32 chain cutter Technical Service Instructions
Реклама
Реклама
General Safety Information
WARNING
• Use neutral detergent to clean the chain. Do not use alkali-based or acid based detergent such as rust cleaners as it may result in damage and/or failure of the chain.
• Use the reinforced connecting pin only for connecting the narrow type of chain.
• If connecting pins other than reinforced connecting pins are used, or if a reinforced connecting pin or tool which is not suitable for the type of chain is used, sufficient connection force may not be obtained, which could cause the chain to break or fall off.
Chain
Reinforced connecting pin
Chain tool
10-speed super narrow chain such as
CN-7800
9-speed super narrow chain such as
CN-7701 / CN-HG93
8- / 7- / 6-speed narrow chain such as
CN-HG50 / CN-IG51
5.6mm
6.5mm
7.1mm
Silver
Silver
Black
TL-CN32 / TL-CN23
• If it is necessary to adjust the length of the chain due to a change in the number of sprocket teeth, make the cut at some other place than the place where the chain has been joined using a reinforced connecting pin. The chain will be damaged if it is cut at a place where it has been joined with a reinforced connecting pin.
Link Pin Link Pin
Reinforced
Connecting Pin
• Check that the tension of the chain is correct and that the chain is not damaged. If the tension is too weak or the chain is damaged, the chain should be replaced. If this is not done, the chain may break and you may fall off the bicycle.
• Obtain and read the service instructions carefully prior to installing the parts. Loose, worn, or damaged parts may cause injury to the rider.
We strongly recommend only using genuine Shimano replacement parts.
• Read these Technical Service Instructions carefully, and keep them in a safe place for later reference.
Technical Service Instructions
TL-CN32
HG/IG/UG
Chain Cutter
SI-1301E
WARNING
Protect eyes with safety glasses or goggles when using this chain cutter.
2.
Remove the holder from the handle, and then take out the pin.
Handle
■ Note
• The chain cutters have two spare pins inside the grips. If a pin becomes worn, replace it with one of the spare pins inside the grip by using the following procedure.
Pin
Holder
3.
Remove the stopper screw from the base of the grip, and then take out a spare pin.
Grip
Pin Replacement Method
The procedure for removing the pin is given below. To install a pin, carry out the removal procedure in reverse.
1.
Remove the handle from the main body of the tool.
Main body
* The grip contains two spare pins.
2
Stopper screw
1
Spare pin
Handle
One Holland, Irvine, California 92618, U.S.A. Phone: +1-949-951-5003
Industrieweg 24, 8071 CT Nunspeet, The Netherlands Phone: +31-341-272222
3-77 Oimatsu-cho, Sakai, Osaka 590-8577, Japan
Please note: specifications are subject to change for improvement without notice. (English)
© Jul. 2003 by Shimano Inc. XBC SZK Printed in Japan t
Изтегляне
Реклама