AVS.4.13.14020/CC-09 Issuing Center: ANTWERP Page 1/2 VERITAS CERTIFICATE OF CONFORMITY To ICAO Annex 14 - Fifth Edition - July 2009 (Standards and recommended practices) To FAA Advisory Circu lar 150/5345-46 To Technical Specification IEC 61827 AENA specification PPT 018-01/08 Product: FEO-x-xxx Clear, Yellow & Red Manufactured by ADB in Belgium Application: Runway Edge & Stopway Lights - was found in conformity with: • the catalogue sheet A.03.211 • the IGAO - Annex 14 - Volume I - §5.3.9; 5.3.15 for light output for 60 m runway • the FAA AG 150/5345-46 mechanical requirements for L-850G Inset Lights • The lEG TS 61827 • The AENA Specification PPT 018-01/08 - Date of inspection: May 29 th , 2013. - and has been, upon request of: ADB Leuvensesteenweg, 585 B - 1930 ZAVENTEM - BELGIUM - inspected in conformity with the applicable requirements of • the catalogue sheets A. 03.211 • the IGAO - Annex 14 - Volume I - §5.3.9; 5.3.15 for light output for 60 m runway • the FAA AG 150/5345-46 mechanical requirements for L-850G • The AENA Specification PPT 018-01/08 & the lEG TS 61827 Issued at Antwerp, May 29th, 2013 Mr Rudi Vandenbempt Inspector Industry BUREAU VERITAS ANTWERP Particulars of inspection: detailed hereafter cEiJ? 3 This certificate is only valid for a period of 5 years from the issuance date, as far as no changes of production process, equipment characteristics nor of applicab le requirements occur during this period of validity. AVS.4.13.14020/CC-09 Issuing Center: ANTWERP Page 2/2 • Attendance to tests at the Laboratory premises of the manufacturer: o Examination of test equipment o Checking of installation of units before testing o Attendance to photometric tests per applicable procedures and method o Attendance to the Colorimetric tests per applicable procedure & method o Attendance to the Static Load test o Attendance to the Surface Temperature test o Attendance to the gas tightness tests • • Statistical test results per IEC 61827 Test results are detailed in the attached test records. CONCLUSION Taking into account the satisfactory results of actual tests and examinations we confirm that the manufacturing and the test results for the above specified units are in conformity with applicable standards, specifications and data sheets. (Details of standards and specifications are indicated on page 1 of this certificate and data sheet as per catalogue). ENCLOSURE Test records of testings which have been attended, duly stamped for identification by BUREAU VERITAS: Photometric test reports: • Results of intensity values inside the beam • Isocandela curves • Colorimetry • Static Load test • Surface temperature test • Gas tightness test Issued at Antwerp, May 29th, 2013 Mr Rudi Vandenbempt Inspector Industry BUR;r;:A~ ;N § RP This certificate is only valid for a period of 5 years from the issuance date, as far as no changes of production process, equipment characteristics nor of applicable requirements occur during this period of validity.
* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project