datasheet for TC2050-ARM2010 by Tag

datasheet for TC2050-ARM2010 by Tag
TC2050-ARM2010 ARM 20-pin to TC2050 Adapter
ARM 20-pin to ARM 10-pin JTAG or ARM SWD using TC2050 Cables Plug-of-N
Cables.
(Pictures for illustrational use only - TC2050-IDC Cable and Segger J-Link Debugger not included! )
Tag-Connect - Save Cost and Space on Every Board!
The TC2050-ARM2010 is a Tag-Connect adapter board allowing our TC2050-IDC cables to be used for ARM JTAG
and ARM SWD (Serial Wire Debug) applications. Although intended for use with our patented TC2050-IDC Plug-ofN
Cables, the adapter may be useful to people wishing to use 10PCB
ARM 20-pin
1 VCC
3 nTRST
5 TDI
7 SWDIO/TMS
9 SWCLK/TCLK
11 RTCK
13 SWO/TDO
15 RESET
17 NC
19 NC/+5V
2 NC
4 GND
6 GND
8 GND
10 GND
12 GND
14 GND
16 GND
18 GND
20 GND
TC2050 10-pin
(JTAG Mode)
1 VCC
2 TMS
3 GND
4 TCK
5 GND/+5V*
6 TDO
7 (Not used)
8 TDI
9 (Not used)
10 RESET
TC2050 10-pin
(SWD Mode)
1 VCC
2 SWDIO
3 GND
4 SWCLK
5 GND/+5V*
6 SWO
7 RTCLK
8 (Not used)
9 nTRST**
10 RESET
** Left: Solder Bridge selects nTRST on pin 9
* Above Right: Solder Bridge selects Debugger +5V on pin 5
Lower Right: Pin 5 is GND (improves signal integrity)
* Pin 5 of the 10-pin connector (pin 5 of TC2050 footprint) can be used to supply power from some debuggers (see
your debugger user guide for details). Solder bridge two pads as shown or select GND to improve signal integrity if
power is not required. Note that some debuggers (ST-LINK/V2 for example) supply +3.3V instead of +5V.
** Pin 9 of the 10-pin connector (pin 9 of the TC2050 footprint) can optionally supply nTRST - solder bridge as shown.
Visit www.Tag-Connect.com for technical support and product info.
Tag-Connect Plug-of-N
C
are protected by U.S. Patent Nos. 7,878,834 & 8,057,248. International Patents Pending
. .
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement