AVS. 4.14.14007/CC-04 Issuing Center: ANTWERP Page 1/2 VERITAS CERTIFICATE OF CONFORMITY The undersigned, Rudi Vandenbempt, acting within the scope of the General Cond itions of BUREAU VERITAS, certifies herewith the supply of RST & RSTE Isolation transform er for 50 & 60 Hz Series lig hting circuits - was found in conformity with: o the c~talogue sheet A.06.112 o the ICAO - Aerodrome Design Manual - Part 5 - 3.2. 1.7 o the IEC 61823 Standard - First Ed ition 12/2002 o the FAA AC 150/5345-47 advisory Circular (L-830 & L-83 1 specifications) o the AENA PPT/006-03/06 for Isolation transformers. Date of inspection: July 18th , 2014 - And has been, upon request of: ADB B.V.B.A. Leuvensesteenweg, 585 B -1930 ZAVENTEM/BELGIUM inspected in conformity with the applicable requ irements of o the catalogue sheet A.06. 112 o the ICAO - Aerodrome Design Manual - Part 5 o the IEC 61823 Standard - First Edition 12/2002 o the FAA AC 150/5345-47 advisory Circular (L-830 & L-83 1 specifications) o the AENA PPT/006-03/06 for Isolation transformers. Issued at Antwerp, July 18th , 2014 Rudi Vandenbempt Inspector Ind ustry BUREAU VER TWERP Particulars of inspection: detailed hereafter This certificate is only valid for a period of 5 years from the issuance date, as far as no changes of production process, equipment characteristics nor of applicable requirements occur during th is period of validity. AVS . 4.14.14007/CC-04 Issuing Center: ANTWERP Page 2/2 ' BW R E .A U: VERITAS The following survey operations have been carried out without noticeable remarks: • Attendance to tests at the Laboratory premises of the manufacturer, • Examination of equipment under test • Checking of installation of unit before testing • Attendance to operational tests according to the applicable procedures and methods • Review of the test report by ETL Intertec Testing Services while certifying same equipment to FAA specifications (07 -068-L-830-83 1; 07 -068-L-823; 07 -068-L-823). • Test results are detailed in the referenced test records: • Electrical properties ( current ratio with varying loads, Power Factor, Efficiency, Insulation resistance, load tests including short circu it, open ci rcuit, minimum & maximum load) • Mechanical and environmental properties (shock resistance, cable pull resistance, gas tightness, temperature rise, ,., ) CONCLUSION Taking into account the satisfactory results of actual tests and examinations we confirm that the manufacturing and the test results for the above specified units are in conformity with applicable standards, specifications and data sheets,; as mentioned on the first page of this certificate, ENCLOSURE Test records of tests which have been attended, duly stamped for identification by BUREAU VERITAS: Inspection test reports: Resu lts of operational tests witnessed. • Test Reports by ETLIITS reviewed for conformance , BUREAU VERITAS ANTWERP This certificate is only valid for a period of 5 years from the issuance date, as far as no changes of production process, equipment characteristics nor of applicable requirements occur during this period of validity.
* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project