5 43-12 | Manualzz

5 43-12
1
5 43-12
SUBJECT
DATE
Removal and Installation of the GHG14 Diesel Oxidation Catalyst Inlet
Pressure Sensor Tube
June 2012
Additions, Revisions, or Updates
Publication Number / Title
DDC-SVC-MAN-0083
Platform
GHG14 DD
Platform
Section Title
Removal of the GHG14
Diesel Oxidation Catalyst
Inlet Pressure Sensor
Tube
Installation of the GHG14
Diesel Oxidation Catalyst
Inlet Pressure Sensor
Tube
All information subject to change without notice.
5 43-12
Copyright © 2012 DETROIT DIESEL CORPORATION
Change
Updates for GHG14 engines.
3
2 Removal of the GHG14 Diesel Oxidation Catalyst Inlet Pressure Sensor Tube
2
Removal of the GHG14 Diesel Oxidation Catalyst Inlet Pressure Sensor
Tube
Remove as follows:
1. Shut off engine and apply the parking brake, chock the wheels, and perform any other applicable safety steps.
2. Disconnect the batteries.
3. Remove the Diesel Oxidation Catalyst (DOC) inlet pressure sensor tube (1) by loosening the tube nut and removing it
from the DOC inlet pressure port (3).
4. Remove the DOC inlet pressure sensor tube (1) from the rubber hose (2) by loosening the hose clamp and sliding the DOC
inlet pressure sensor tube (1) out of the rubber hose (2).
4
All information subject to change without notice.
Copyright © 2012 DETROIT DIESEL CORPORATION
5 43-12
5 43-12
3
Installation of the GHG14 Diesel Oxidation Catalyst Inlet Pressure Sensor
Tube
Install as follows:
1. Apply anti-seize on the tube nut threads, then install into the port on the 1-BOX (3).
NOTE: If pressure tube is replaced, replace hose and clamps also.
2.
3.
4.
5.
Install the DOC inlet pressure sensor tube (1) into the rubber hose (2).
Tighten hose clamp.
Torque the tube nut to 27-30 N·m (20-22 lb·ft).
Connect the batteries.
All information subject to change without notice.
5 43-12
Copyright © 2012 DETROIT DIESEL CORPORATION
5

Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project