null  null
Installation Instructions
1. Remove passenger seat.
2. Locate fender wires and un-plug from main harness.
WIRING DIAGRAM
3. Remove the 3 bolts securing the OEM fender to
motorcycle.
TM
V a r i a b l e
A x i s
L o c k i n g
4. Remove fender assembly.
Wiring Harness
V.A.L.E.
2009 Yamaha
E x h a u s t
5. Cut OEM wires on fender assembly back 6” (inches) from
plugs.
R1
Fender Eliminator Kit
Part # 013-238
6. Attach gray plug to left side turn signal using the supplied
buttsplace connector.
7. Attach black plug to right side.
(G
Black
9. Attach turn signals and plate lights to TBR fender and
attach using the OEM bolts and supplied 6mm flange nuts
to motorcycle.
10. Route wires through center hole and plug into main
harness.
Blue/Red
8. Attach the 2 bullet connectors to the plate light bolts.
Black goes to black.
Red goes to blue/red.
al
igntor)
S
c
urnonne
T
t
f c
Le rey
Rig
(Bl ht T
ack ur
co n S
nn ign
ec
to al
Plate Lights
11. Use zip-tie tabs and zip-ties to keep wires away from
exhaust.
Description
Part Number
1
2
1
6
2
2
3
1
Fender Bracket
Lighted License Plate Bolt
Turn Signals (set of 2)
Butt Splice Connectors
Zip Tie
Zip Tie Tab
6mm Flange Nut
TBR Sticker Kit
005-23804B
005-8504LTZ
005-88T2
005-BS1614
005-ZT458B
005-ZTM4
005-FN6
015-10212
IMPORTANT - PLEASE READ CAREFULLY
We recommend that this performance part be installed by a qualified motorcycle
technician. If you have any doubts as to your ability to install this performance
part, please consult with your local motorcycle dealer. Read all instructions first
before starting installation. Make sure the motorcycle and exhaust system are
completely cool before starting the installation. Also, make sure the bike is secure
on a centerstand or ideally a service lift during installation. Be sure to save all stock
components for possible use later.
Warranty
Two Brothers Racing products are intended for closed course competition purposes only, and therefore are sold “as is”
without warranty. Two Brothers Racing specifically disclaims any warranties of merchantability or fitness for a particular
purpose and disclaims all responsibility for consequential and incidental damages or any other losses arising from the
use of these products or parts.
Bla
Red
ck
Qty.
14. Before you run the bike, clean off all fingerprints and
dirt, as any oily residue will etch the metal and become
somewhat permanent when the system gets hot. Also,
remove any plastic film from the name badge(s) and or
canister clamp(s). Run the bike and enjoy. It is normal
for some white smoke to appear the first time you start
the bike. This is packing/manufacturing oil from inside
the pipe burning off. Check for gaps or leaks. If you find a
leak, a little high temperature silicon sealant should fix it.
After 50 to 100 miles, recheck all fasteners for tightness.
Bla
Parts List
d
Re
13. Re-install passenger seat.
ck
12. Double check all your work.
r)
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement