Installation Instructions Compression fitting CF10-50N CF06-25N

Installation Instructions Compression fitting CF10-50N CF06-25N
Installation Instructions
Compression fitting
704493 / 00
10 / 2008
CF10-50N
CF06-25N
► Insert the fitting (C) into the
process connection and tighten.
► Use an appropriate seal if required
for the application.
A
EA
GR
► Grease all parts of the adapter:
coupling nut (A), ferrule (B), thread
and cone of the fitting (C).
C
SE
B
C
► Position the ferrule.
NOTE: tapered end into the cone.
► Attach the coupling nut and insert
the sensor (D).
I
D
2
► Tighten the coupling nut manually
and mark its position with a line
(E).
E
► Adjust the sensor to the required
installation depth.
► Hold it and tighten the coupling nut
a maximum of 2 full turns.
Repeated mounting
You can remove the sensor e.g. to clean the tip. Then insert the sensor again and
tighten the coupling nut being careful not to apply too much force.
3
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising