Bin Sensor Installation Instructions

Bin Sensor Installation Instructions
BIN SENSOR
NEW LEADER
INSTALLATION INSTRUCTIONS
Stay out of the spreader. If it’s necessary to enter the spreader, return to the shop, empty
body, turn off all power, set vehicle brakes, lock engine starting switch and remove keys
WARNING
before entering. Tag all controls to prohibit operation. Tags should be placed, and later
removed, only by person working in the body.
BINBIN
SENSOR
SENSOR
LEAD
SHORT18"
LEAD
Bin 2
Bin 1
BIN SENSOR
BIN SENSOR
LONG
LEAD
78" LEAD
Figure 1 – Bin Sensor Locations
2
Page Rev. A
UCTIONS
RN
IO
ST
AT
IN
LL
ON
TA
N SI
I N S TA L LI AT
The following instructions are to be used as a guideline only. Flow characteristics vary depending on product,
moisture/humidity, etc.
1. Find a suitable location to mount the bin level sensor inside rear of spreader. Figure 1 shows suitable locations
and positioning in bin 1 and bin 2. (The bin 1 sensor is approximately 12” (30.48) from the conveyor and 4-1/2”
(11.43cm) from the side sheet. The bin 2 sensor is approximately 16” (40.64cm) from the conveyor and 2-1/2”
(6.35cm) from the side sheet.)
2. Use the sensor as a template to mark the mount and cable hole locations.
3. Drill two 3/16” (.48cm) holes for mounting and one 1” (2.54cm) hole for the cable. Deburr all holes.
4. Mount sensor using hardware provided.
5. Route sensor cables to rear of unit. Front bin sensor cable should be routed between insert and side sheet and
through insert endgate.
6. Route controller cable along side of unit and plug into sensor.
7. Use tie wraps as necessary to secure the cable.
8. To test sensor with stand alone control box (pn 98787-B): Turn it on and the light should illuminate and a buzzer
should sound. Cover sensor and the light and buzzer should turn off.
To test sensor with “7” controller: Turn on controller and go to run screen. A warning message should appear
specifying which channel (bin) is low. Cover sensor and warning should go away.
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement