Migrating your data from Drobo to Drobo FS

Migrating your data from Drobo to Drobo FS
Migrating Your Data from Drobo to Drobo FS
To move your data from another model to Drobo FS, connect both computers simultaneously and copy the files you'd
like to share.
Moving your data from any model Drobo to a Drobo FS:
1. Connect Drobo FS to your network and ensure it has sufficient free capacity to accommodate the additional data
from your Drobo.
2. Copy ALL files from Drobo to Drobo FS.
3. Verify ALL files are in place and fully accessibly on Drobo FS
4. If you would then like to add the drives from the Drobo to the Drobo FS, remove the drives from Drobo and place
them one at a time in the free data bays in Drobo FS.
Note that this will ERASE ALL DATA on these drives. This step cannot be undone. If you aren't sure that
you've successfully copied all data onto Drobo FS, do not complete this step.
Drobo Ÿ 2460 North First Street, Suite 100, San Jose, CA 95131 Ÿ www.drobo.com Ÿ 1.866.97.DROBO
Copyright 2011 Drobo, Inc. Data Robotics, Drobo, DroboElite, DroboPro, Drobo, BeyondRAID, and Smart Volumes are trademarks of Drobo, Inc.,
which may be registered in some jurisdictions. All other trademarks used are owned by their respective owners. All rights reserved.
Specifications subject to change without notice. Ÿ TS-0063-00 Ÿ October 2011
Page 1 of 2
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement