FEATURES TYPICAL SPECIFICATIONS

FEATURES TYPICAL SPECIFICATIONS
Project/Location:
Contractor:
Date:
GRA Series
Prepared by:
Die-Cast LED Exit Sign
Lumacell Model:
FEATURES
•Housing of Die-Cast Aluminum in a variety of finishes
•Slim-line canopy for top and end mounting
•Universal mounting or: wall, end, or ceiling
•Universal, field-selectable knock-out chevrons
•Long-life LED light source. Red LED’s of ALINGAP technology
•Dual voltage input: 120/347VAC 60Hz
•Low power consumption: less than 3.5 Watts in any configuration
•Self-Powered models with sealed maintenance-free Nickel-Cadmium batteries
•CSA approved
•Five-year full warranty
DIMENSIONS
Dimensions are approximate and subject to change.
85/8” [21.9 cm]
91/8” [23.1 cm]
51/2” [13.9 cm]
43/8” [11.1 cm]
127/8” [32.7 cm]
17/8” [4.7 cm]
TYPICAL SPECIFICATIONS
Stylish built in Die-Cast aluminum, the new GRA Series offer superior
workmanship, versatile mounting capabilities and economical, long-lasting
LED performance.
Supply and install the Lumacell® GRA Series Exit Sign. The frame, face plate(s), back
plate and canopy shall be constructed of Die-Cast aluminum of ______ finish and
______ color. No screws are necessary to hold the faceplate(s) or the back plate to
the housing. The unit shall be suitable for installation on wall, end, or ceiling mount.
The faceplates shall come standard with knockout chevrons. The light source shall
be light emitting diodes (LEDs).
Red LED technology shall be ALINGAP. The LEDs shall provide illumination in normal
and emergency operation and shall be mounted inside the exit housing, not on the
face. A LED-sensitive diffuser shall be mounted in front of the LEDs to provide the
6” high by ¾” stroke letters with even illumination. The Exit Sign in a Self-Powered
configuration shall be equipped with a sealed, maintenance-free Nickel-Cadmium
battery. The equipment shall operate with a dual-voltage input of 120/347VAC 60Hz
with less than 3.5W of consumption. The equipment shall stay illuminated at least
90 minutes upon AC failure. The Exit Sign shall be listed to UL924 standard and be
approved for use in Damp Locations.
When specified, the Self-Powered model equipped with advanced diagnostic shall
self-test by simulating a power failure for one minute every 30 days, 30 minutes
every 60 days and 90 minutes every 360 days. A diagnostic circuit shall continuously
monitor the performance of the battery, charger module and LED lamps. Upon failure
detection the system shall display the error on the AC pilot lamp, which will change
color from green to red and will flash with a specific code. The red light shall be
steady-on in case of “Battery Disconnect”; it shall flash with one blink for “Battery
failure”, two blinks for “Charger failure” and four blinks for “LED lamp failure”. A label
with the diagnostic legend shall be visible next to the pilot light.
The Exit Sign shall be Lumacell® Model:
.
POWER CONSUMPTION
MODEL
AC SPECS
DC SPECS
AC only
120/347VAC
Less than 2.5W
-
-
AC/DC remote
120/347VAC
Less than 2W
6 to 48VDC
Less than 1.5W
Self-Powered
120/347VAC
Less than 3.5W
Nickel-Cadmium battery
Minimum 90 minutes
Self-Powered with diagnostic
120/347VAC
Less than 3W
Nickel-Cadmium battery
Minimum 90 minutes
ORDERING INFORMATION
SERIES
GRAD=
LED Die-Cast
ENCLOSURE
COLOUR
BA= black/ brushed
aluminum
A= brushed alumium
WA= white/ brushed
aluminum
W= factory white
B= black
UNIT TYPE
AC= AC only
AC2C1= dual AC circuit (2 x 120V)
UNV= 120/277 or 120/347VAC & 6 to 48VDC
SDN= S elf-Powered diagnostic
Nickel-Cadmium (90 Min)
SPN= S elf-Powered Nickel-Cadmium
(90 Min)
NEX= NEXUS® system interface (90 Min)*
NEXRF= NEXUS® wireless system interface
(90 Min)*
*Consult your sales representative for options
available with NEXUS® system.
VOLTAGE
Blank= dual AC circuit only
2= 120/277VAC
3= 120/347VAC
LEGEND
COLOUR
OPTIONS
R1= single face red
R2= double face red
G1= single face green
G2= double face green
TP= tamper proof screws*
VRTP= polycarbonate shield with
tamper proof screws
990.0119-L**
*Indicate single or double face
** One bit needed per order
EXAMPLE: GRADAAC2R1
www.lumacell.com
25
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement