DIGITRONIC MICROMETER INSTRUCTIONS
Digitronic Micrometer 201 Series
Please carefully review these instructions to ensure proper and accurate use of your new Digitronic Micrometer.
2 3 4
Features
1. Frame
2. Anvil
3. Spindle
4. Locking device
5. Thimble
6. Frame insulator
7. Function buttons
8. LCD display
9. SPC output
1
6
7
LCD Display
in: Inch measuring mode
mm: Metric measuring mode
ABS: No symbol present
8
9
5
Operation
• Keys are pressed two ways to execute functions:
1. Press and immediately release
2. Press and hold for at least two seconds
On/Off - Zero Key
• Press and release: Power on/off
• Press and hold: Zero set for absolute measuring ("Set" will appear)
ABS/INC - Unit Key
• Press and release: Absolute and INC measuring mode conversion
• Press and hold: Inch/Metric conversion ("in" will appear for inch readings, "mm" will appear for metric readings)
Data Output
In measuring mode, this is the data output key
• Press and release: The micrometer will output the displayed data
• Press and hold: The micrometer will output the displayed data continually until the button is pressed again
For more information visit www.moore-and-wright.com Partners in Precision
MW201-01DAB_Manual_A4.indd 1 08/05/2012 10:03
DIGITRONIC MICROMETER INSTRUCTIONS
Power
• If the micrometer is not used for five minutes the power will automatically shut off
Powering off the micrometer by pressing the "On/Off— Zero key to save the battery when not in use is recommended
• Use a CR2032 battery and replace the battery when the display begins to blur
• Remove the battery cap by turning it counterclockwise with a coin or the supplied wrench.
Insert a new battery with (+) side up. Replace the battery cap by turning it clockwise
Data Output
• The output interface is a RS-232C
• The micrometer can be attached to a PC’s serial port by an SPC cable
• To attach the cable, remove the data output cap and insert the cable
• When not using the interface, always keep the data output cap in place
Serial Port Information
• Baud rate: 1200 Kb/second
• Stop bits: 2
General Specifications
• Measuring force: 5-10N
• Operating temperature: 0-40°C
• Storage temperature: -20-60°C
• Parity: none
• Data bits: 7
Precautions
• Do not subject the instrument to blows or shock. Do not drop it or apply excessive force
• Do not disassemble the instrument
• Do not press the keys with a pointed object
• Do not use or store the instrument under direct sunlight
• Avoid exposing the instrument to strong magnetic fields and high voltage
• Use a soft cloth to clean the instrument. Never use organic solvents such as acetone or benzene to clean
• Clean measuring faces before use
• If the instrument is to be stored or left unused for extended periods, remove the battery
Troubleshooting
Problem(s)
Measuring data incorrect
No display on LCD
1. Flickering display
2. Display is sporadic
3. Display remains dead
1. Display is blurry
2. Output data is incorrect
Cause(s)
1. Dirty measuring faces
2. Zero is incorrect
1. Battery position is incorrect
2. Battery is dead
1. Weak battery
2. Weak battery
3. Battery position is incorrect
1. Weak battery
2. Weak battery
Solution(s)
1. Clean measuring faces
2. Inspect and reset zero
1. Reset battery
2. Replace with new battery
1. Replace battery
2. Replace battery
3. Reset battery
1. Replace with new battery
2. Replace with new battery
For more information visit www.moore-and-wright.com Partners in Precision
MW201-01DAB_Manual_A4.indd 2 08/05/2012 10:03
