SKC grab air pump man 40098 0 2011 02

SKC grab air pump man 40098 0 2011 02
Operating Instructions
Grab Air Sample Pump
Catalog No. 222-2301
SKC Inc.
863 Valley View Road
Eighty Four, PA 15330
Form #40098 Rev 1102
2
Description
The SKC Grab Air Sample Pump is an economical choice for grab-and-go bag
sampling. Grab Air operates at a fixed flow rate of 1 L/min for up to 1000 liters
volume on one 9-volt battery. Simply attach a sample bag to the outlet port and
turn on the pump. Simple, quick, economical — Grab Air.
Pump inlet port
Pump exhaust port
for bag sampling
Case screws
Remove to
access battery
On/Off switch
Low battery
LED indicator
Case screws
Remove to
access battery
Grab Air Sample Pump, Cat. No. 222-2301
3
Performance Profile
Flow Rate .............................................. 1 L/min
Operation Time .................................. Approx. 1000 liters volume per battery dependent
on battery quality
Battery.................................................... Disposable 9-volt alkaline
Pumping Action .................................. Diaphragm
Case ........................................................ Sturdy, lightweight plastic
Intrinsic Safety .................................... Not intended for use in hazardous locations
Protect sample pump from weather when in use outdoors.
Failure to follow warnings and cautions voids any warranty.
4
Operation
1. Check battery. If the low battery LED on the pump is lit, insert a fresh 9-volt
alkaline battery.
a. Remove four case screws and remove the pump faceplate.
b. Remove the old battery, insert the new battery, replace the faceplate, and
secure with case screws.
Before use, allow pump to equilibrate after moving it from one temperature
extreme to another.
2. Attach PTFE tubing to the exhaust fitting on the top of the pump. Attach the
free end of the tubing to the inlet valve on the sample bag. See bag operating
instructions for details on operation of bag fitting(s).
Protect
sample
pump from
weather
when in use
outdoors.
Grab Air bag sampling train
3. Slide the pump's On/Off switch to On.
Do not operate pump in hazardous locations.
4. Sample until the bag is filled properly.
Properly Filled Bag
Improperly Filled Bag
5. Slide the pump's On/Off switch to Off.
6. Disconnect the tubing, close the bag inlet valve, identify the sample, and send
to a laboratory for analysis.
The pump should be purged after bag sampling. To purge the pump, run
it for several minutes in a clean air environment. If the contaminant is
hazardous, take all necessary safety precautions.
Failure to follow warnings and cautions voids any warranty.
5
SKC Limited Warranty and Return Policy
SKC products are subject to the SKC Limited Warranty and Return Policy,
which provides SKC’s sole liability and the buyer’s exclusive remedy. To
view the complete SKC Limited Warranty and Return Policy, go to http://
www.skcinc.com/warranty.asp.
6
7
www.skcinc.com
8
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement