Celestron 21061 Refractor User Guide

Add to My manuals

advertisement

Celestron 21061 Refractor User Guide | Manualzz

2 www.celestron.com

Quick set-up guide for:

Model #21061 – AstroMaster 70AZ

Model #21063 – AstroMaster 90AZ

Questions or Problems with Set-up?

CONTACT: Celestron Technical Support:

310 .

803 .

5955

3

Quick Set-up Guide

1

Your AstroMaster 70AZ/90AZ includes: optical tube w/ built-on StarPointer finderscope, pre-assembled tripod with center leg brace and altazimuth mount attached; two eyepieces; erect image diagonal, accessory tray, lens cloth, battery, owner’s manual, and The Sky™ CD Software.

To set up the tripod, spread the legs outward until they are fully extended. Extend each of the three tripod legs down 6-12".

Use the three tightening screws located at the bottom of each leg to secure the extended legs in place.

4 5 6

All three legs should be the same length to provide a level platform for the telescope.

7

To attach the accessory tray, line up notches and turn clockwise until tray tabs lock into place with the tripod brackets.

8

Properly assembled, the accessory tray should appear as pictured above.

9 dovetail mount fastening screws

Here is how the fully assembled tripod and mount should appear.

Next slide telescope tube into the mount. Be sure to back out fastening screws to allow enough clearance for the dovetail.

Center dovetail in the mount and tighten fastening screw. For added security tighten the angled lock down screw next to the fastening screw.

Quick Set-up Guide [cont]

10 11 12

Loosen the set screw on the focuser. Remove the plastic cap covering the end of the focuser.

Insert the diagonal into the focuser and tighten the set screw.

Insert the chrome barrel of the 20mm eyepiece into the diagonal and tighten the set screw.

13 15 battery battery cover

14 on/off switch

Unscrew battery cover for the StarPointer finderscope. Insert battery with “+” side facing out.

16

Replace battery cover and tighten. For longer battery life be sure to turn off finderscope when not in use.

Remove the lens cap from the front of the telescope before you begin observing.

You are now ready to start using you AstroMaster telescope.

For detailed usage information please consult your owner’s manual.

WARNING: Never attempt to view the sun through any telescope without proper filtering!

advertisement

Related manuals

Download PDF

advertisement