Power Supply & Junction Schematic Diagram < VCR Section >
For continued protection against fire hazard,
replace only with the same type fuse.
The voltage for parts in hot circuit is measured using
hot GND as a common terminal.
Fixed voltage (or Auto voltage selectable) power supply circuit is used in this unit.
If Main Fuse (F1001) is blown , check to see that all components in the power supply
circuit are not defective before you connect the AC plug to the AC power supply.
Otherwise it may cause some components in the power supply circuit to fail.
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF