BAND-IT Ties Installation Instructions

BAND-IT Ties Installation Instructions
Installation
Instructions
BAND-IT Ties
Maximum Operating Temperature: Coating = 300°F (149°C)
Rated Load (Loop Tensile Strength, single wrap) :
1/4” Tie = 75 LBS
3/8” Tie = 100 LBS
5/8” Tie = 200 LBS
Rated Load (Loop Tensile Strength, double wrap) :
1/4” Tie = 300 LBS
3/8” Tie = 500 LBS
5/8” Tie = 800 LBS
1. Wrap BAND-IT tie around object with the
locking ears up. Wrap per diagram at left.
2. Tighten BAND-IT ties with one of these
(listed in order of increasing tension):
• By hand,
• BAND-IT AE201 Tensioning Hook,
• BAND-IT AE200 Tensioning Tool,
• BAND-IT C075 Bantam Tool.
3. Bend tail back over raised bridge.
4. Secure tail under ears by slightly pushing
the tail sideways and down, first one way
then the other.
5. Tail may be left on for re-use.
6. Optional: Hammering down the bridge may
increase the strength of the lock, but will not
allow the clamp to be re-used.
Refer to website for warranty information: http://www.band-it-idex.com/warranty.html
WWW.CABLEJOINTS.CO.UK
THORNE & DERRICK UK
TEL 0044 191 490 1547 FAX 0044 477 5371
TEL 0044 117 977 4647 FAX 0044 977 5582
WWW.THORNEANDDERRICK.CO.UK
www.BAND-IT-IDEX.com
www.BAND-IT.co.uk
Page 1 of 1
www.BAND-IT-clamps.com
Document # P91787 rev. F
© Copyright
BAND-IT-IDEX, Inc. 2008
All rights reserved
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement