Slip-On (2004
Installation
1. Make sure the bike is completely cool before starting the
installation. Make sure the bike is secure on the sidestand
or ideally a rear service stand.
2. Remove OEM heat shield.
3. Remove OEM Muffler assembly. Make sure gasket is
removed also.
4. Use the 6x14mm socket head cap screws and split lock
washers to loosely join the s-bend to muffler. Do not
tighten yet.
2009 Honda
CB300
Slip-on Exhaust System with A-2 Canister
Part # 005-2710402V
Parts List
Qty.
Description
Part Number
1
1
1
1
1
1
1
4
4
1
1
1
1
1
A-2 Muffler Canister
Slip-On Tube
Muffler Canister Clamp
HARDWARE KIT
Stainless X-Ring
57mm Barrel Clamp
34mm Spacer 6x14mm Socket Head Cap Screw
6mm Split Lock Washer
8x50mm Socket head Cap Screw
8mm Flat Washer
5mm Long Handle Ball End Hex Key
T20 Torx Short Hex Key
TBR Sticker Kit
005-271-202M
005-27104S
005-2C
005-271-3
005-7-2-A2
005-27-57MSH
005-S-34
005-SH614
005-WL6
005-SH850
005-W08
005-9-18610
005-9-15820
015-10212
IMPORTANT - PLEASE READ CAREFULLY
We recommend that this performance part be installed by a qualified
motorcycle technician. If you have any doubts as to your ability to install
this performance part, please consult with your local motorcycle dealer.
Read all instructions first before starting installation. Make sure the
motorcycle and exhaust system are completely cool before starting the
installation. Also, make sure the bike is secure on a centerstand or ideally
a service lift during installation. Be sure to save all stock components for
possible use later.
5. Slide supplied barrel clamp over slip-on tube end.
6. Slide rubber lined muffler clamp over muffler assembly.
7. Attach muffler assembly to motorcycle using the supplied
bolt and spacer with the OEM nut. The spacer goes
between the clamp and mounting bracket.
8. Align muffler and tighten the 4 X-ring bolts.
9. Tighten muffler clamp and barrel clamp at slip-tube joint.
10. Double check all your work.
11. Before you run the bike, clean off all fingerprints and
dirt, as any oily residue will etch the metal and become
somewhat permanent when the system gets hot. Run
the bike and enjoy. It is normal for some white smoke to
appear the first time you start the bike. This is packing/
manufacturing oil from inside the pipe burning off.
Check for gaps or leaks. If you find a leak, a little high
temperature silicon sealant should fix it. After 50 to 100
miles, recheck all fasteners for tightness.
Care & Cleaning
Care & Cleaning
Keep system free of dirt and moisture. Store in a cool, dry place. Make sure vehicle is
completely cool before maintenance.
Brushed Aluminum Canisters: Clean using a mild water based spray cleaner. Always
apply cleaner or polish with a soft, clean cloth.
Repack all road canisters every 3,000 miles. Part #005-10038
Repack all offroad canisters after every 10 hours of use. Part #005-10038MX
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement