01r0518

01r0518
IBM
Technical Update

Important instructions for installing the IBM ServeRAID-5i Ultra320
SCSI controller 2-U bracket
The IBM ServeRAID-5i Ultra320 SCSI controller has a 3-U bracket. If your server requires a low-profile
2-U bracket, you must use the following instructions to install the 2-U bracket.
Attention: Failure to follow these instructions might damage the ServeRAID-5i controller.
Complete the following steps to install the 2-U bracket. You will need a small, flat-blade screwdriver. Also,
be sure to observe the proper electrostatic discharge procedures.
1. Holding the controller by the edges, remove it from the static-protective package.
2. Set the controller battery-side down on a nonconductive, static-protected surface. Do not place the
controller on your server cover or on a metal table.
3. Using a small, flat-blade screwdriver, remove the screw from the battery pack.
4. To remove the battery, gently press the tab up and lift the battery away from the controller.
Tab
Alignment pin
Battery
IBM and ServeRAID are trademarks of the IBM Corporation in the United States, other countries, or both.
 Copyright International Business Machines Corporation 2002. All rights reserved.
Note to U.S. Government Users — Documentation related to restricted rights —use, duplication or disclosure is subject to
restrictions set forth in GSA ADP Schedule Contract with IBM Corp.
Part Number: 01R0518
Printed in the U.S.A.
*1P01R0518*
1
5. Remove the two bracket screws. Set them aside.
6. Remove the 3-U bracket.
7. Align the two screw holes in the 2-U bracket with the two screw holes on the controller. Using the two
screws you removed in step 5, secure the bracket to the controller. The screws enter the screw holes
on the battery side of the controller and then go through the bracket screw holes.
Attention: Follow steps 8 and 9 carefully. Failure to do so might damage the controller.
8. Carefully reposition the battery pack on the controller. Be sure that the alignment pin and the two tabs
are properly aligned.
Tabs
Alignment pin
Battery
9. Press gently on the center of the battery pack to snap the battery pack into place. Be sure to apply
pressure evenly with both hands and to hold the controller as shown in the figure below. Also, make
sure that the tab is properly latched on the controller.
10. Using the screw you removed in step 3 on page 1, secure the battery to the controller.
2
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement