UID COMMON TECH-SPEC 02-15
Technical Specifications
UniStream™ Uni-I/O™ Modules
UID-0808R, UID-0016R, UID-0808T,
UID-0016T, UID-1600
This guide provides specifications for Unitronics’ Uni-I/O™ Modules.
Uni-I/O modules are compatible with UniStream™ Programmable Logic Controllers. They may be either
snapped onto the back of a UniStream™ HMI Panel next to a CPU-for-Panel to create an all-in-one HMI
+ PLC controller, or installed on a standard DIN Rail using a Local Expansion Kit.
Installation Guides are available in the Unitronics Technical Library at www.unitronics.com.
This specification sheet refers to the models in the following table:
Part no.
UID-0808R
UID-0016R
UID-0808T
UID-0016T
UID-1600
Inputs
8
-
8
-
16
Type
Sink (pnp) or
Source (npn),
24VDC
-
Sink (pnp) or Source (npn),
24VDC
Outputs
8
16
8
Type
Relay, 24VDC (power supply)
Isolation
All inputs and outputs are isolated
Inputs
UID-1600
UID-0808R, UID-0808T
Number of inputs
16
8
Type
Sink or Source
Isolation groups
Four groups of 4 inputs each
Sink (pnp) or
Source (npn),
24VDC
16
Transistor, Source (pnp),
24VDC
Two groups of 4 inputs each
Isolation voltage
Group to bus
Group to group
Input to input within
group
Nominal voltage
500VAC for 1 minute
500VAC for 1 minute
None
24VDC @ 6mA
Input voltage
Sink/Source
On state: 15-30VDC, 4mA minimum
Off state: 0-5VDC, 1mA maximum
Nominal impedance
4kΩ
Filter
Settable between 1 to 32 ms (individually per group)
Unitronics
1
2/15
UniStream™
Outputs
UID-0808R
UID-0016R
UID-0808T
UID-0016T
Number of outputs
8
16
8
16
Output type
Relay, SPST-NO (Form A)
Transistor, Source
Isolation groups
Two groups of
4 outputs each
One group
of 8 outputs
Four groups of
4 outputs each
One group
of 16 outputs
Isolation voltage
Group to bus
1,500VAC for 1 minute
500VAC for 1 minute
Group to group
1,500VAC for 1 minute
-
None
None
None
500VAC for 1 minute
1,500VAC for 1 minute
None
2A maximum per output
(Resistive load)
0.5A maximum per output.
Voltage
250VAC / 30VDC maximum
See Outputs Power Supply
specfication
Minimum load
1mA, 5VDC
-
ON state voltage drop
-
0.5V maximum
OFF state leakage
current
-
10µA maximum
Switching times
10ms maximum
Turn-on/off: 80µs max. (Load
resistance < 4kΩ)
None
Yes
100k operations at maximum load
-
Output to output
within group
Output power supply
to bus
Output power supply
to output
Current
Short-circuit protection
Life expectancy
(1)
Outputs Power Supply UID-0808R
UID-0016T: total cumulative output current
for O4-O7 and O12-O15 cannot exceed 2A.
UID-0016R
UID-0808T
UID-0016T
Nominal operating
voltage
24VDC
Operating voltage
20.4 – 28.8VDC
Maximum current
consumption
[email protected]
[email protected]
[email protected]
[email protected]
IO/COM Bus
UID-0808R
UID-0016R
UID-0808T
UID-0016T
UID-1600
Bus maximum current
consumption
100mA
90mA
110mA
120mA
100mA
Unitronics
(2)
(2)
2
UID-0808R, UID-0016R, UID-0808T, UID-0016T, UID-1600
Technical Specifications
LED Indications
Input LEDs
Green
Input state
Output LEDs
Green
Output state
Status LED
A triple color LED. Indications are as follows:
Color
Green
Green/Red
Red
Orange
LED State
Status
On
Operating normally
Slow blink
Boot
Rapid blink
OS initialization
Slow blink
Configuration mismatch
On
Output short-circuit
(models with transistor outputs)
Slow blink
No IO exchange
Rapid blink
Communication error
Rapid blink
OS Upgrade
Environmental
Protection
IP20, NEMA1
Operating temperature
-20°C to 55°C (-4°F to 131°F)
Storage temperature
-30°C to 70°C (-22°F to 158°F)
Relative Humidity (RH)
5% to 95% (non-condensing)
Operating Altitude
2,000m (6,562 ft)
Shock
IEC 60068-2-27, 15G, 11ms duration
Vibration
IEC 60068-2-6, 5Hz to 8.4Hz, 3.5mm constant amplitude, 8.4Hz to
150Hz, 1G acceleration.
Unitronics
3
2/15
UniStream™
Dimensions
UID-0808R
UID-0016R
UID-0808T
UID-0016T
UID-1600
Weight
0.15 Kg
0.17 Kg
0.13 Kg
0.13 Kg
0.13 Kg
(0.331 lb)
(0.374 lb)
(0.287 lb)
(0.287 lb)
(0.287 lb)
Size
Identical for all models, as shown in the images below
Top View
Side View
Unitronics
Front View
4
UID-0808R, UID-0016R, UID-0808T, UID-0016T, UID-1600
Technical Specifications
Notes
1. Life expectancy of the relay contacts depends on the application that they are used in. The product’s
installation guide provides procedures for using the contacts with long cables or with inductive loads.
2. Current consumption does not include load current.
The information in this document reflects products at the date of printing. Unitronics reserves the right, subject to all applicable laws, at any time, at its sole
discretion, and without notice, to discontinue or change the features, designs, materials and other specifications of its products, and to either permanently or
temporarily withdraw any of the forgoing from the market.
All information in this document is provided "as is" without warranty of any kind, either expressed or implied, including but not limited to any implied warranties
of merchantability, fitness for a particular purpose, or non-infringement. Unitronics assumes no responsibility for errors or omissions in the information
presented in this document. In no event shall Unitronics be liable for any special, incidental, indirect or consequential damages of any kind, or any damages
whatsoever arising out of or in connection with the use or performance of this information.
The tradenames, trademarks, logos and service marks presented in this document, including their design, are the property of Unitronics (1989) (R"G) Ltd. or
other third parties and you are not permitted to use them without the prior written consent of Unitronics or such third party as may own them.
DOC27004-A7 02/15
Unitronics
5
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement