Lantronix XPress-Pro SW Quick Start Guide
Add to my manuals2 Pages
Lantronix XPress-Pro SW is a compact and rugged Ethernet switch designed for harsh environments and space-constrained applications. It supports 802.3/802.3u/802.3x protocols, auto-negotiation for speed and duplex, and auto MDI/MDIX. With 8 ports, including 10/100BaseTX and 100BaseFX connections, it provides versatile connectivity options. The switch operates on a wide range of DC voltages (10-48V) and has low power consumption, making it energy-efficient. It also features store-and-forward mechanism, non-blocking architecture, broadcast storm filtering, and support for up to 2K MAC addresses.
advertisement
XPress-Pro SW 52000 Quick Start
This quick installation guide describes how to install and use the hardened compact Ethernet Switch. Capable of operating at temperature extremes of
-10°C to +60°C, this is the switch of choice for harsh environments constrained by space.
Physical Description
The Terminal Block and Power Input
The Terminal Block
Earth Ground
DC Terminal Block Power Input: The DC Terminal Block power input can be used to power up this Switch.
The 10/100BaseTX and 100BaseFX Connectors
The 10/100BaseTX Connections
The following lists the pinouts of 10/100BaseT/TX ports.
Pin Regular Ports
1 Input Receive Data +
2
3
Input Receive Data -
Output Transmit Data +
4 NC
5 NC
6 Output Transmit Data -
7 NC
8 NC
The 100BaseFX Connections
The fiber port pinouts
The Tx (transmit) port of device I is connected to the Rx (receive) port of device II, and the Rx (receive) port of device I to the Tx (transmit) port of device II.
Uplink port
Output Transmit Data +
Output Transmit Data -
Input Receive Data +
NC
NC
Input Receive Data -
NC
NC
Number
May 2007
1
The Port Status LEDs
10/100TX or 100FX
LINK/ACT
Steady
Flashing
A valid network connection established.
LINK stands for LINK.
Transmitting or receiving data.
ACT stands for ACTIVITY.
Steady The port is transferring at 100Mbps.
100
Off
The port is transferring at 10Mbps If this
LED is dark.
Functional Description
Support 802.3/802.3u/802.3x. Auto-negotiation: 10/100Mbps, Full/half-duplex; Auto MDI/MDIX.
100BaseFX: Multi mode SC and ST type; Single mode SC or ST type; WDM Single mode SC type.
Support 2K MAC addresses.
Store-and-forward mechanism.
Full wire-speed forwarding rate and non-blocking mechanism.
Broadcast storm filtering.
Operating voltage and Max. current consumption: 12VDC @ 0.71A, 24VDC @ 0.37A, 48VDC @ 0.22A. Power consumption: 10.56W Max.
Power Supply: DC Terminal Block power input, 10-48VDC.
Operating temperature ranges from -10 ℃ to 60℃.
Plastic compact Din-rail industrial case design.
Assembly, Startup, and Dismantling
Assembly: Place the switch on the DIN rail from above using the slot. Push the front of the switch toward the mounting surface until it audibly snaps
into place.
Startup: Connect the supply voltage to start up the switch via the terminal block.
Dismantling: Pull out the lower edge and then remove the switch from the DIN rail.
2
advertisement
* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project