Dual XD622W Owner's Manual

XD622W

INSTALLATION/OWNERS MANUAL

AM/FM/CD Weather Receiver

XD622W INSTALLATION

Preparation

Please read entire manual before installation.

Before You Start

• Disconnect negative battery terminal. (consult a qualified technician for instructions)

• Avoid installing the unit where it would be subject to high temperatures, such as from direct sunlight, or where it would be subject to dust, dirt or excessive vibration.

Getting Started

• Remove 2 transit screws located on top of the unit.

• Insert the supplied keys into the slots as shown, and slide the unit out of the mounting sleeve.

• Install mounting sleeve into opening, bending tabs to secure.

• Connect wiring harness and antenna. (consult a qualified technician if you are unsure)

• Certain vehicles may require an installation kit and/or wiring harness adapter (sold separately).

• Test for correct operation and slide into mounting sleeve to secure.

• Snap trim ring into place.

SECURITY

LED

SECURITY

LED

2

TYPICAL MOUNTING METHOD

XD622W INSTALLATION

Wiring Diagram

FUSE

When replacing a fuse, make sure new fuse is the correct type and amperage.

Using an incorrect fuse could damage the radio.

The XD622W uses one

10 amp ATM fuse located beside the wiring connector.

3

XD622W OPERATION

Control Locations

1 2 3 4 5 6 7 8 9 10

20 19 18 17 16 15 14 13 12 11

6

7

4

5

1

2

3

8

9

10

Release

Power

Audio

Scan

Display

Auto Store/Preset Scan

EQ

Tune/Track Down

Eject

Tune/Track Up

16

17

14

15

11

12

13

18

19

20

Mode

Bass Boost

Preset 6

Preset 5

Preset 4

Preset 3/CD Intro

Preset 2/CD Random

Preset 1/CD Repeat

Play/Pause/Band

Mute

4

*Semi-permanent

Faceplate Attachment

For semi-permanent faceplate installation, remove trim ring and install supplied Phillips head #1 screw through left side of mounting frame into faceplate.

XD622W OPERATION

General Operation

Faceplate Removal Press RELEASE and pull away from the left side to remove.

To re-install, insert right side of faceplate first then push left side to secure.

Power On/Off Press PWR or any other button (except eject) to turn the unit on. Inserting a CD will turn the unit on automatically. Press

PWR to turn the unit off.

Mode Press MODE to select between AM/FM tuner, weatherband tuner, CD player and auxiliary input. Modes of operation are indicated in the display.

Bass Boost Press BASS to activate and deactivate bass boost curve.

Activating this feature will enhance the bass frequencies when listening to music at all volumes.

Volume Adjust volume using rotary encoder (00-46).

Programmable

Turn-On Volume

Press and hold PWR for 3 seconds to program currently selected volume level.

Confirmation Beep Press rotary encoder for 3 seconds to turn confirmation beep on/off.

Mute Press MUTE to silence the audio. Press MUTE again to cancel.

Preset EQ Curves Press EQ to select between POP, JAZZ, CLASSIC, BEAT, ROCK and OFF (default) equalization curves. Any adjustment to the

Bass or Treble settings automatically cancels the current EQ curve.

Display Press DISP to select between clock and radio frequency

(tuner mode) or CD track/elapsed time (CD player mode).

Set the Clock With the unit on, press and hold DISP until clock begins to flash, then release. Press TUNE

TUNE to adjust the hours and to adjust the minutes. Press DISP momentarily to save the selected time.

12/24-hour Clock The clock will display 12-hour AM/PM time in U.S. frequency spacing mode (PM 10:00). In European frequency spacing mode, the clock will display 24-hour time (22:00).

5

6

XD622W OPERATION

General Operation

Programmable

Display Priority

Press and hold DISP then press TUNE to select radio frequency (tuner mode) or CD track/ elapsed time (CD player mode) display priority (default). Clock is accessed by pressing DISP momentarily.

Press and hold DISP then press TUNE to select clock display priority. Radio frequency or CD track/elapsed time is accessed by pressing DISP momentarily.

Programmable

Clock Priority

Programs unit to display clock/no clock when unit is off.

Press and hold MODE then press PRESET 1 to turn clock priority on/off.

Reset Press and hold for more than 2 seconds to RESET the unit upon initial installation or if abnormal operation occurs. The

RESET button is located behind the faceplate.

Audio Press rotary encoder to select between Volume (default),

Bass, Treble, Balance & Fader.

Bass Press rotary encoder until BASS appears

Rotate encoder left/right to adjust

(+6 maximum / -6 minimum)

Treble Press rotary encoder until TRE appears

Rotate encoder left/right to adjust

(+6 maximum / -6 minimum)

Balance Press rotary encoder until BAL appears

Rotate encoder left/right to adjust

(L12-0-R12) 00 represents equal balance.

Fader Press rotary encoder until FAD appears

Rotate encoder left/right to adjust

(F12-0-R12) 00 represents equal fader.

Source Audio Memory Individual Bass and Treble settings are retained in memory for AM, FM, Weatherband, CD and AUX modes.

XD622W OPERATION

AM/FM Tuner Operation

Seek Tuning Press TUNE strong station.

or momentarily to seek the next

Manual Tuning Press TUNE or for more than 2 seconds, then release. "MANU" will momentarily appear in the display.

Press TUNE or momentarily to move radio frequency up or down one step at a time. Press and hold to advance quickly. If tuning is not adjusted for 5 seconds, the unit will return to seek tuning mode (default). "AUTO" will momentarily appear in the display.

Scan Tuning Press SCAN to preview strong stations on the current band, pausing for 5 seconds at each. Press SCAN again to cancel.

Band Press BAND to select between FM1, FM2, FM3 and AM1,

AM2 bands.

Frequency Spacing Press and hold BAND then press TUNE to select

European frequency spacing. Press and hold BAND then press TUNE to select U.S. frequency spacing (default).

Anytime frequency spacing is changed, all station presets are erased.

Storing and Recalling

Station Presets

Up to 18 FM stations and 12 AM stations can be stored. To store a station, select the desired band and station. Press and hold the desired preset button for more than 2 seconds.

When stored, the preset number will appear in the display.

The station can be recalled anytime by pressing the corresponding preset button.

Automatically

Store Stations

Press AS/PS for more than 3 seconds to automatically store the six strongest stations in the current band. Automatic

Local/Distance is activated during the initial band scan.

Preset Scan Press AS/PS to scan presets 1-6 on the current band, pausing for 5 seconds at each. Press AS/PS again to cancel.

7

8

XD622W OPERATION

Weatherband Tuner Operation

Manual Tuning Press TUNE or weatherband station.

momentarily to seek the next

Direct Tuning Press preset 1~6 or BAND to directly access the 7 weatherband stations. Refer to the table below.

Button

Preset 1

Weatherband Stations - Direct Tuning Table

WB Frequency LCD Display

162.400 MHz Wb - 1

Preset 2

Preset 3

162.425 MHz

162.450 MHz

Wb - 2

Wb - 3

Preset 4

Preset 5

Preset 6

BAND

162.475 MHz

162.500 MHz

162.525 MHz

162.550 MHz

Wb - 4

Wb - 5

Wb - 6

Wb - 7

XD622W OPERATION

CD Player Operation

Insert CD With the label facing up, insert a standard size CD into the

CD slot. The CD will automatically begin playback.

Eject CD Press the EJECT button to stop and eject the CD. The unit will change to previous mode of operation (AM/FM tuner,

Weatherband tuner or auxiliary input). If the disc is not removed within 10 seconds, the unit will reload the disc.

The unit does not have to be turned on to eject CD.

Track Select Press TRACK to skip to the beginning of the next track.

Press TRACK to return to the beginning of the current track. Pressing TRACK again skips to the beginning of the previous track.

Fast Forward and Reverse

Press and hold TRACK or reverse a track.

Pause or TRACK

Press l / II to temporarily stop CD playback.

Press l / II again to resume playback.

to fast forward

Intro Press INT to play the first 10 seconds of each track.

Press INT again to cancel.

Repeat Press RPT to continuously repeat selected track. Press RPT again to cancel.

Random Press RDM to play all tracks in random order. Press RDM again to cancel. Random mode is retained in memory when selecting between modes and when the unit is turned on/off.

CD-R Compatibility Some CD-Rs may be incompatible with this unit, depending on media type and recording method. This model does not support CD-RWs.

9

XD622W WARRANTY

Limited One-Year Warranty

This warranty gives you specific legal rights.

You may also have other rights which vary from state to state.

Namsung America Inc. warrants this product to the original purchaser to be free from defects in material and workmanship, under normal conditions, for a period of one year from the date of the original purchase.

Namsung America agrees, at our option, during the warranty period, to repair any defect in material or workmanship or to furnish an equal new or renewed product in exchange without charges, subject to verification of the defect or malfunction and proof of the date of purchase.

During the One-Year Warranty Period: For One Year from the date of purchase, your product will be replaced with a new, renewed or comparable product

(whichever is deemed necessary) if it becomes defective or inoperative. This is done without charge to you. Replacement products are warranted for the balance of the original warranty period.

Who is covered? This warranty is extended to the original retail purchaser for products purchased and used in the U.S.A., in the 48 contiguous states ONLY.

What is covered? This warranty covers all defects in material and workmanship in this product. The following are not covered: installation/removal costs, damage resulting from accident, misuse, abuse, neglect, product modification, improper installation, incorrect line voltage, unauthorized repair or failure to follow instructions supplied with the product, or damage occurring during return shipment of the product.

What to do?

1. Before you call for service, check your operating instructions. A slight adjustment of any custom controls may save you a service call.

2. If you require service during the warranty period, you must carefully pack the product (preferably in the original package) and ship it by prepaid transportation with proof of the purchase date from the retailer to the Return Center address listed below.

3. Please describe your problem in writing and include your name, a return UPS shipping address

(P.O. Box not acceptable), and a daytime phone number with your shipment.

4. DUAL will pay the return shipping charges if the product is returned to an address within the USA.

Namsung America Inc.

Attn: Returns Center

21318 64th Ave. South

Kent, WA 98032 U.S.A.

Toll Free: 1-866-626-7863

Exclusion of Certain Damages: This warranty is exclusive and in lieu of any and all other warranties, expressed or implied, including without limitation the implied warranties of merchantability and fitness for a particular purpose and any obligation, liability, right, claim or remedy in contract or tort, whether or not arising from the company’s negligence, actual or imputed. No person or representative is authorized to assume for the company any other liability in connection with the sale of this product. In no event shall the company be liable for indirect, incidental or consequential damages.

10

XD622W OPERATION

Specifications

CD Player Signal-to-noise: >92dB

Frequency response: 10Hz-20kHz

Channel separation @ 1kHz: >65dB

D/A converter: 1 Bit

FM Tuner Tuning range: 87.5MHz-107.9MHz

Usable sensitivity: 8.5dBf

50dB quieting sensitivity: 10dBf

Stereo separation @ 1kHz: 40dB

Frequency response: 30Hz-13kHz

AM Tuner Tuning range: 530kHz-1710kHz

Usable sensitivity: 22uV

Frequency response: 30Hz-2.2kHz

Wetherband Tuner Tuning range: 162.400MHz-162.550MHz

General Total power output: 208 Watts Peak

Power output: 52Wx4 @ 4 ohms, 14.4 VDC

Operating voltage: 11-16 VDC, negative ground

Speaker output impedance: 4~8 ohms

Line output voltage: 2V

Dimensions: 7" x 7" x 2" (178 x 178 x 51 mm)

Design and specifications subject to change without notice

11

XD622W OPERATION

Troubleshooting

Problem

Unit will not turn on

(no power)

Unit has power

(but no sound)

Unit blows fuses

Excessive skipping

ER02 appears on display

ER03 appears on display

ER04 appears on display

ER06 appears on display

ER07 appears on display

ER08 appears on display

ER09 appears on display

Cause

Yellow wire not connected or incorrect voltage

Red wire not connected or incorrect voltage

Black wire not connected

Fuse blown

Speaker wires not connected

One or more speaker wires touching each other or touching chassis ground

Yellow or red wire touching chassis ground

Speaker wires touching chassis ground

Incorrect fuse rating

Unit is not mounted correctly or backstrap is not secure

Physical defect in media (CD or CD-R)

Load/Eject operation error

Focus adjustment error

Tracking auto adjustment error

Sled operation error

Focus error or disc is in upside down

CLV (PLL) operation error

TOC data read error

Action

Check connections for proper voltage

(11~16VDC)

Check connection to ground

Replace fuse

Check connections at speakers

Insulate all bare speaker wires from each other and chassis ground

Check for pinched wire

Check for pinched wire

Use fuse with correct rating

Check mounting sleeve and backstrap support

Check media for scratches

Press eject or RESET

Clean or replace media

Clean or replace media

Press eject or RESET

Press eject or RESET

Press eject or RESET

Clean or replace media

Namsung America Inc.

21318 64th Ave. South

Kent, WA 98032

Toll Free: 1-866-626-7863 www.dualav.com

©2004 Namsung America, Inc.

EVOK0404-V01