Body-Solid TF3i Endurance TF3i Folding Treadmill Assembly Manual

Add to My manuals
6 Pages

advertisement

Body-Solid TF3i Endurance TF3i Folding Treadmill Assembly Manual | Manualzz

ENDURANCE TF3i

VERSION 0409

ENDURANCE

TF 3 i

HARDWARE ILLUSTRATION SHEET

Qty.

A1. M4X10 Round Cross Screw--------------------[2pcs]

A2. M8X16 Round Inner Hex Screw---------------[6pcs]

A3. M10X95 Round Inner Hex Screw--------------[4pcs]

C1. M8 (I.D)Washer----------------------------------[4pcs]

C2. M10 (I.D)Washer---------------------------------[4pcs]

C3. M8 (I.D)Radian Washer------------------------[2pcs]

A1

A2

A3

C1

C3

C2

20 40 60 80 100 120 140 160

PAGE 1

ENDURANCE TF3i HARNWARE ILLUSTATION SHEET

A[1PCS]

D[1PCS]

C[1PCS]

B[1PCS]

E[1PCS]

F[1PCS]

G[1PCS]

H[1PCS]

PAGE 2

ENDURANCE TF3i

D

Assemble Procedures: 1.B

2.C

3.D

4.F

5.OTHERS

Do not tighten the bolts down completely during first assembly.

After the completion of step 3,then you may tighten the boltscompletely.

C

F

A1

B

A2

C3

C1

A2

A3

A3

C2

PAGE 3

A

Do not tighten the bolts down completely during first assembly.

After the completion of step 3,then you may tighten the boltscompletely.

ENDURANCE T F 3 i

After assembly and before turning power on position the rear roller using the ' T ' wrench ( refer to the drawing if needed ) .

make 3 turns

If belt is too far to the left side

1) turn the left roller bolt 1/4 turn clockwise(tighten)

2) turn the right roller 1/4 turn counterclockwise(loosen)

If belt is too far to the right side

1) turn the right roller bolt 1/4 turn clockwise(tighten)

2) turn the left roller bolt 1/4 turn counterclockwise(loosen)

PAGE 4

ENDURANCE T F 3 i

TENSIONING THE BELT

Running Belt

If when you plant your foot on the belt , you can feel a sliping sensation then the belt has been stretched and is slipping over the roller.

This is normal and common adjustment on a new treadmill.

To eliminate this slipping , tighten both sides of the rear roller by wing a Allen wrench turn 1/4 of a TURN as shown above .Try the treadmill again to check for slipping.

Repeat if necessary . but NEVER TURN the roller bolt more than 1/4 turn at a time.

CAUTION:OVER TIGHTENING OF THE ROLLER WILL SEVERELY SHORTEN

THE LIFE OF THE BELT AND MAY CAUSE FURTHER DAMAGE TO OTHER

Drive Belt

If you have tightened the running belt and are still experiencing a slipping sensation , call your Steel Flex Dealer . Tightening of the drive belt should only be performed by an authorized dealer.

PAGE 5

advertisement

Related manuals

Download PDF

advertisement