UHF/VHF/FM ACTIVE COLOR ANTENNA INSTALLATION AND OPERATING INSTRUCTIONS 1 4 5

UHF/VHF/FM ACTIVE COLOR ANTENNA INSTALLATION AND OPERATING INSTRUCTIONS 1 4 5
UHF/VHF/FM ACTIVE COLOR ANTENNA INSTALLATION AND OPERATING INSTRUCTIONS
1
4
5
Antenna
Antenna
Power
supply
unit
First insert the U-bolt into the fixed mount. Then mount the fixed U-shaped mount,
tighten with the hex nuts as shown in the diagram above.
2
*
TV1
Power
supply
unit
Black
*
Red
TV2
12V *
* not included
* not included
Insert the assembled fixed mount screw into the antenna body screw notch,
tighten with the nuts underneath the fixed mount as shown in the diagram above.
Connect your antenna to the power
supply unit, and the power supply unit to
one or two TVs.
Plug the power supply unit into a wall
outlet or use the red and black cable for
the power supply by a car battery*.
6
3
Tighten the cable onto the F-connector. After it is tightened, insert the water seal
onto the antenna body as shown in the diagram above.
Unscrew the wing screw and deploy the two antennas, adjust the antennas for an optimal
reception.
SPECIFICATIONS
FREQUENCY: VHF 40~230MHz, UHF 470~862MHz
GAIN: VHF 20dB, UHF 19dB
FRONT BACK RATIO: UHF 16 ~ 6, VHF 0
HALF POWER ANGLE: UHF 55° ~ 65°, VHF 60° ~ 80°
OUTPUT IMPEDANCE: 75Ω, F FEMALE CONNECTOR
VOLTAGE STANDING WAVE RATIO: 2~3
NOISE FIGURE: 5dB Max.
MAX. OUTPUT LEVEL: 95dBµV (IMA -60dB)
APPLICABLE TEMPERATURE: -20°C ~ +50°C
WIND SURFACE: 0.181m2
WIND LOAD: 12.67 KPA
FIXED MAST DIAMETER: 15~56mmØ
POWER SOURCE: 12V
100mA
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising